Assessments - 1, GPA: 4 ( )

Fabricante : GE Monogram Arquivo Tamanho: 1.18 mb Arquivo Nome : Língua de Ensino:

ADDED HEAT When selected, the cycle will run longer with the heating element on to improve both wash and dry performance. NOTE: Cannot be selected with RINSE ONLY cycle. DELAY HOURS You can delay the start of a wash cycle for up to 9 hours. Touch the DELAY HOURS pad to choose the number of hours you want to delay the start of the cycle; then touch START/RESET one time. The dishwasher will count down and start automatically at the correct time. Touching START/RESET a second time will cancel the DELAY START selection. RESET To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle. The START/RESET light will flash while the water is pumped out if needed. This takes approximately 90 seconds. When the light stops flashing, the dishwasher can be reprogrammed and restarted. Start Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad once to begin the cycle. Water begins to fill the dishwasher, and approximately 60 seconds later the wash action begins. Touching the START/RESET pad a second time will cancel the cycle and cause the water to drain out. This will take approximately 2 minutes. NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher door is fully closed, the control panel lights will display the last settings you selected. If you don’t want to change any of the settings, simply touch the START/RESET pad once to begin the cycle. If the door is closed, the indicator lights will turn off if the START/RESET pad is not pressed within two minutes. To activate the display, open and close the door or touch any pad. Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. 5 Consumer SupportTroubleshooting Instructions 5 Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips About the dishwasher control panel. (For models without a sensor: EDW5000 Series, GHDA450 Series, GLD4100 Series, GLD4200 Series, GLD4300 Series, GLD5500 Series, and GLD5800 Series) You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model. 1 342 Control Settings 1 Status Indicator Lights The Status display tells you what’s happening while the dishwasher is in operation and may flash, indicating a malfunction (see page 8). The lights will come ON indicating the sequence of operation the dishwasher is in. SANITIZED Displayed when cycle has met sanitization conditions. Light remains ON until door is opened. 2 CLEAN Displayed when a wash cycle is complete. The light stays ON as a reminder that the dishes are clean until the door is opened or until another cycle is selected. Cycles The light above the selected pad will be ON to indicate which cycle has been selected. SANI WASH 7.3 gal., 97 min. This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle length will vary depending on the temperature of your inlet water. NOTE: The SANI-WASH cycle is monitored for sanitization requirements. If the cycle is interrupted during or after the main wash portion or if the incoming water temperature is so low that adequate water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the sanitized light will not illuminate at the end of the cycle. NOTE: NSF certified residential dishwashers are not intended for licensed food establishments. POTS 8.5 gal., 89 min. & PANS This cycle is meant for heavily soiled dishes or cookware with dried-on or...

Baixe o seu

Para fazer o download, introduza 2 dígitos :