Log:
Assessments - 5, GPA: 4.4 ( )

Instruções de Operação Mabe Canada, Modelo GSD3000

Fabricante : Mabe Canada
Arquivo Tamanho: 1.26 mb
Arquivo Nome :
Língua de Ensino: en
Ir para baixar



Facilidade de uso


Be sure the door is unlatched. 2 Short Wash or Light Wash or Water Saver For quickly washing loads of everyday dishes with light to medium soils that have not dried on. Be sure the door is unlatched. 3 Latch the door to start the cycle. 1 Slowly turn the Dial to SHORT WASH, 2 LIGHT WASH or WATER SAVER. Start Delay (on some models) The START DELAY will allow you to delay the start time of any cycle automatically up to 6 hours. Be sure the door is unlatched. Slowly turn the Dial to the desired time. 13 The CYCLE ON light will come on. Select the wash cycle and option you want. 4 Latch the door to start the cycle. 2 Start (Models with a Dial) Slowly turn the Dial to the START or ON position, or the selected cycle. Don’t turn it past the START, ON or cycle position; you could accidentally miss a prewash. There is a time delay between start-up and water fill so you will not hear any wash action right away. Latch the door to begin the cycle. 7 Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips Operation of electronic models (model GSD4000 Only) Using the Dishwasher Door The door must be closed and locked into place to select a LOAD SELECTION or an OPTION. 1 If the door is opened during a cycle and left open, the dishwasher will beep once every 30 seconds until the 2 door is closed and latched into place. Start Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and approximately 60 seconds later the wash action begins. NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON and display the last settings you selected. If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle. Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle. Clean This light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened. Flashing Display Lights Lights What It Means What To Do RESET STARTSTART This is normal. Allow the dishwasher to drain and reset before you start a new The START/RESET pad wash cycle. has been pressed. Control Error Press the START/RESET pad to turn off the beeper. If the CLEAN light continues to flash, call for service. PLUS A BEEPING SOUND CLEANCLEAN Control Error Press the START/RESET pad to turn off the beeper and the dishwasher will attempt to reset. Restart the wash cycle. If this error continues, turn off the power to the dishwasher at the circuit breaker for 30 seconds. Try the dishwasher again. If the error is still present, call for service. PLUS A BEEPING SOUND 8 Safety Instructions Operating Instructions Troubleshooting Tips Consumer Support Filling the Dispenser Fill the rinse agent dispenser until it reaches the bottom of lip inside the opening. Replace cap. To check if rinse agent is needed, remove the cap and look into the dispenser. A full dispenser should last about one month. If the rinse agent spills, wipe up the excess. Check the Water Temperature The entering water must be at least 120°F and not more than 150°F, for effective cleaning and to prevent dish damage. Check the water temperature with a candy or meat thermometer. Turn on the hot water faucet nearest the dishwasher, place the thermometer in a glass and let the water run continuously into the glass until the temperature stops rising. Adjust the maximum/minimum temperature of the water heater if necessary to deliver water at the proper temperature. Use Jet-Dry® Rinse Agent Proper Use of Detergent Jet-Dry® or Cascade Crystal Clear® rinse agents remove spots and prevent new film buildup on dishes, glasses, flatware, cookware and plastic. Use only detergent specifically made for use in dishwashers. Cascade® and E...

Este manual também é adequado para os modelos :
Máquinas de lavar louça - GHDA300 (1.26 mb)
Máquinas de lavar louça - GSD1000 (1.26 mb)
Máquinas de lavar louça - GSD2000 (1.26 mb)
Máquinas de lavar louça - GSD4000 (1.26 mb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias