Assessments - 3, GPA: 3.7
(
)
)
|
Facilidade de uso
This appliance complies with the following EEC directives: -73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications; -89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications. -Carefully dispose of the packing material. -After removing the packing, check to make sure that the appliance is not damaged. If in doubt, contact a qualified professional. -The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. -Fundamental rules to follow when using the appliance: * Never touch the dishwasher when bare foot or with wet hands or feet; * We discourage the use of extension cords and multiple sockets; * During installation, the power supply cord must not be excessively or dangerously bent or flattened; Close-up View (Control Panel) A B * If the appliance is not operating properly or maintenance must be performed, disconnect the appliance from the power supply. -Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. -This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. -Do not touch the heating element during or after a wash cycle. -Do not lean or sit on the door when it is open, as this could overturn the dishwasher. -If the appliance malfunctions, turn off water supply to the appliance and disconnect the plug from the wall socket. Then, consult the section entitled, "Troubleshooting". If you can not solve the problem, contact a service centre. -Only specialised personnel are authorised to make repairs. -Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock. -The appliance must be positioned so that the plug is accessible. -The carpet must not obstruct the opening when the appliance installing on the ground with carpet. -If the supply cord is damaged ,it must be replaced by the manu facture ,its service agent of similarly qualified persons in order to avoid a hazard. C D E A ON-OFF Light D Handle For Opening Door B Low Salt Indicator Light E Knob For Selecting Cycle C ON-OFF Button .1. Close-up View (Interior) GB A Upper Rack E Washing Filter B Rack Height Adjustor F Bottom Spray Arm C Top Spray Arm G Detergent and Rinse Aid Dispenser D Lower Rack H Salt Container Cap Technical characteristics Width 45 cm Depth 60 cm Height 85 cm Capacity 9 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage 220-240V~ 50Hz Total absorber power 1900W .2. Salt .. Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the Salt into the Softener Always use salt intended for use with dishwashers. The salt container is located beneath the lower rack and should be filled as follows: -Remove the lower rack and then unscrew and remove the cap from the salt container; -If you are filling the container for the first time, fill it with water; -Place the end of the funnel (supplied) into the hole and introduce about 2 kg of salt. It is normal for a small amount of water to come out of the container. -Carefully screw the cap back on. The salt container should be filled after about every 30 wash cycles. To prevent the formation of rust, load the salt just before beginning a wash cycle. GB Adjusting Salt Consumption The dishwasher is equipped with a system to adjust the level of salt consumption in function of the hardness of the water being used in order to optimize and customize the level of salt consumption while keeping it to a minimum. To adjust salt consumption level, follow these instructions: -Unscrew the cap on the salt container; -On the container there is an arrow (see figure to the side). If necessary, turn the arrow in the anti-clockwise direction from the "-" setting to the "+" setting based on the hardness of the water being used. -It is highly recommended that the table be consulted when making adjustments . Water Hardness Clarke degrees cdH mmol/l Selector position Salt consumption (Grams/cycle) Autonomy (cycles/2kg) 014 MNT MNIT L M L NQPS NUQQ NIUQIQ =?J? OM SM PSTN QRUV QIRUIV jba QM QM [TN [UV [UIV ?H? SM OR .3. Detergent and Rinse Aid.. Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table". The detergent dispenser is located on the inside panel of the door. Loading the detergent To open the "A" cover on the dispenser, press the "B" button. The detergent for the wash cycle should be poured into the "C" compartment. After the detergent has been placed in the dispenser, close the cover and press ...
Este manual também é adequado para os modelos :Máquinas de lavar louça - DW9-AFM (490.13 kb)
Máquinas de lavar louça - DW9-AFMS (490.13 kb)