Assessments - 2, GPA: 5
(
)
)
|
Facilidade de uso
china, pots/ pans, cutlery, glasses, etc Type of food remains Amount of food remains Condition of food remains Description of cycle • g Intensive Wash Non-del icate Soups, casseroles, sauces, potatoes, pasts, rice, eggs, roast or fried food. a lot stuck on hard Pre-wash with warm water. Extended wash at 70°C. Rinses with cold water. Rinse with hot water. Drying. t No W 3 rmal ash Pre-wash use cold water. Extended wash at 55°C. Rinse with cold water. Rinse with hot water. Drying. \_/ \_/ \_/ Light Wash Mixed Soups, potatoes, pasta, rice, eggs, roast or fried food. a little loosely attached Pre-wash use cold water. Extended wash at 50°C. Rinse with cold water. Rinse with hot water. Drying. ? Glassware Coffee,cakes, milk, sausage, cold drinks, salads Very little loosely attached Wash at 45°C. Rinse with warm water. Hot rinse. Drying. £ Rapid wash Short wash at 40°C. Cold rinse. / Hea l\\ twash For dishes that need to be rinsed and dried only. Hot rinse at 65°C. Drying. // :\\| //¿y Soak Rinse off If the dishes have been stacked for several days in the dishwasher prior to washing. Short cold wash to prevent food residue from drying on the dishes . 14 en Detergent Rinse Aid .aboratory measured valve in accordance with European Standard EN50242 Duration in Energy Water Prewash Extended Wash minutes consumption In kWh consumption In litres 5g 25g • 112 1.62 18 5g 25g • 102 1.24 16 5g 25g • 162 1.05 15 — 25g • 92 1.12 12 — 15g — 32 0.40 9 — 15g • 54 0.50 5 — — — 12 0.02 3 15 Washing dishes en Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc,, as well as the amount and condition of food remains, with the details contained in the wash cycle table.The corresponding programme sequence, duration and consumption details are shown in the right half of the overview, For example: Use the “Normal Wash” Q programme for dishes and utensils which have plenty of food remains stuck on hard. Earn savings If only a small number of dishes have been loaded into the dishwasher,selecting a programme that operates at the next lowest temperature will usually be sufficient. Programme data The stated programme data are based on standard operating conditions. The values can vary considerably according to: • different amounts of dishes • temperature of mains water supply • pressure of mains water supply • ambient temperature • fluctuations in mains voltage • machine-related factors (e.g. temperature, water volume,...) Turning on the Appliance Starting a wash cycle... • Make sure that the plug for the appliance is inserted into the wall socket. • Make sure that the water supply is turned on to full pressure. • Load the dishwasher, • Pour in the detergent, • Press the ON-OFF button, and the “stop” light will turn on. • Turn the knob located on the right of the control panel until the number or symbol for the cycle setting is aligued with the refrence mark (see the section entitled, program overview).If the knob rightly aligned with the refrence mark you want to choose, you must turn the knob to with the mark of “Reset” .Then back to first step, • After 3 seconds the “stop” light will turn off, the wash cycle will begin, 16 en At the end of the wash cycle... When the buzzer constantly beeps six times, the “stop” light will turn on and the cycle has finished. Turn off the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. Cancelling or modifying a wash cycle setting... A cycle that is underway can only be modified if it has been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent'), Reset drain Rotate the knob to the mark of “Reset”,the appliance will take a few minute drain phase. During this process, you can select right programme, 17 How to keep your dishwasher in shape en After Every Wash After every wash, turn off the water supply (not necessary for models with “Aquastop”) to the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, always remove the plug from the socket, Do not run risks, No solvents or Abrasive Cleaning Products To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products. Rather, use only a cloth and warm soapy water. To remove spots or stains from the surface of the interior, use a cloth dampened with water and a little while vinegar, or cleaning product made specifically for dishwashers. Moving...
Este manual também é adequado para os modelos :Máquinas de lavar louça - DW12-EFETME (26.37 mb)
Máquinas de lavar louça - DW12-EFETS (26.37 mb)