Assessments - 3, GPA: 4.7 ( )

Fabricante : Asko Arquivo Tamanho: 330.72 kb Arquivo Nome : Língua de Ensino:

There are three components of the filtering system: the main filter, the coarse filter, and the fine filter. Page 6 CLEANING THE FILTERS TERSTERS CLEANING THE FIL In hard water areas, it may be necessary to clean tabs and lifting it out. Next, unscrew the fine filter and lift chemical buildup from the filters every 12 to 18 months. it and the main filter out. Wash all three filters gently in To do this, remove the coarse filter by squeezing the hot, soapy water and rinse them thoroughly. CLEANING THE DOOR CLEANING THE DOORCLEANING THE DOOR To clean the edge around the door, use only a soft warm, damp rag. To prevent penetration of water into the door lock and electrical components, do not use a spray cleaner of any kind. Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will scratch the finish. Some papers towels can also scratch or leave marks on the surface. WARNING! Never use a spray cleaner of any kind on the door panel. You could damage the door lock and electrical components. And never use abrasive cleaners or scouring pads on the outer surfaces because they will scratch the finish. Also, some paper towels can scratch or leave marks on the stainless steel surface. CLEANING THE SPRAY ARMS CLEANING THE SPRAY ARMS Spray-arm jets and bearings may sometimes become the spray arm and lift off the arm. Wash the spray arms clogged with hard water chemicals. To remove the spray in warm, soapy water. Use a soft brush to clean the jets. arms, screw off the nut and take off the washer on top of Rinse thoroughly and replace. CLEANING THE DRAIN PUMP CLEANING THE DRAIN PUMPCLEANING THE DRAIN PUMP On occasion something may get through the filters and into the drain pump. The drain pumps on ASKO dishwashers are designed to automatically reverse if anything should get caught in the propellers, thus ejecting the item back into the sump area or down the drain. Should you need to remove an obstacle from the drain, first turn the power off then remove the filters (as explained on page 6). Next, lift out the small black insert from the sump area. (You might want to remove any standing water first.) You can then look into the sump area for the item causing the obstruction. Should you find something, simply scoop it out. Be sure to replace the black insert before you put the filters back in. WARNING! Never run the dishwasher without the filters in place. To reach an item caught in the drain pump, remove the filters then the small black insert in the sump area. OOVERFILL PRVERFILL PROOTECTIONTECTION Your ASKO dishwasher has an overfill protection device If there is water in the base pan due to an overfill or that automatically shuts off the inlet valve and starts the small leak, the water must be removed before the drain pump if the water level in the unit should rise above dishwasher will start. the normal level. If this happens, turn the water off at the main supply and call for service. OVERFILL PROTECTION ON OUR ELECTRONIC MODELS OVERFILL PROTECTION ON OUR ELECTRONIC MODELS When an overfill is detected on Models D1776, D1796FI, On Models D1776, D1876, D1976 and D1976CUS, the D1876, D1996, D1976, and D1976CUS, all of the LED window will also display a fault code (F2). indicator lights on the control panel will flash at once. ENERENERGY SAGY SAVINGVING TIPSTIPS ¦ If you plan to wash the dishes right away, there’s no ¦ Don’t use the Temp boost for lightly soiled dishes. need to pre-rinse. Simply scrape off large particles ¦ Avoid using Heat dry. (You can speed up the dryingand load the dishes. process by opening the door slightly to release the ¦ Wash only full loads. moist air.) ¦ Use the Pan prog...

Baixe o seu

Para fazer o download, introduza 2 dígitos :