Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
aluminium utensils. Plastic parts discoloured. Too low rinsing temperature. Select programme with higher washing temperature. Utensils precleaned too intensely; Do not prerinse utensils. Remove only large sensors therefore decide on food remnants. weak programme sequence. Stubborn soiling cannot be completely removed. aus Fault, what to do? Fault Cause Remedial action Removable streaks on Too much rinse aid. Set rinse aid amount to lower setting. metallic appearance and cutlery. No rinse aid added or setting too low. Add rinse aid and check dosage (recommended setting 4-5). Detergent residue in the final rinse programme section. Detergent dispenser cover blocked by utensils (cover does not open fully). Detergent dispenser cover must not be obstructed by utensils. Do not place utensils or fragrance dispenser in the tablet collecting tray. Utensils precleaned too intensely; sensors therefore decide on Do not prerinse utensils. Remove only large food remnants. weak programme sequence. Stubborn soiling cannot be completely removed. Initial or existing, irreversible clouding of glass. Glasses not dishwasher-proof, only suitable for dishwasher. Use dishwasher-proof glasses. Avoid long steam phase (standing time after wash cycle ends). Use wash cycle at lower temperature. Use detergent with glass protection component. Rust spots on the cutlery. Cutlery not adequately rust- resistant. Knife blades are Use corrosion-resistant cutlery. frequently more severely affected. Cutlery will also rust if rusting parts are rinsed at the same time (pan handles, damaged utensil baskets, etc.). Do not wash rusting parts. The appliance does not The mains fuse has tripped. Check mains fuse. start. Power cord not inserted. Ensure that the power cord is plugged all the way into the back of the appliance and into the socket. Check that the socket functions. The appliance door has not been shut properly. Close the door. Programme starts automatically. You did not wait until programme ended. Perform reset. (See Terminating the programme). The door is difficult to open. Child-proof lock is activated. Deactivate childproof lock. (See instructions for use at the back) Door cannot be closed. Door lock has been activated. Close door with increased force. Door cannot be closed due to installation. Check appliance installation: Door or attached parts must close without obstruction. glasses, glasses with Fault, what to do? aus Fault Cause Remedial action Cover on the detergent Detergent dispenser or cover Remove detergent residue. dispenser cannot be guide blocked by sticky detergent closed. residue. Detergent residue Spray arms blocked by utensils, Ensure that the spray arms can rotate freely. in the detergent dispenser therefore detergent is not rinsed or in the tablet collecting out. tray. The detergent dispenser was Pour detergent into the dry detergent damp when filled. dispenser only. Appliance stops Door not closed properly. Close the door. in the programme or programme is interrupted. Do not place utensils or fragrance dispenser in the tablet collecting Check whether rear panel is being pressed in, e.g. by socket or by hose holder which tray. has not been removed. Top basket presses against inner door and prevents door from being closed securely. Power and/or water supply Restore power and/or water supply. interrupted. Filling valves making Depends on domestic installation, No remedial action possible. striking noises. as appliance is not defective. No effect on appliance function. Knocking or rattling noise. Spray arm strikes the utensils, Position utensils so that the spray arms do utensils not positioned correctly. not strike the utensils. If there is a low load, the water Load the appliance with more utensils or jets strike the washing tank distribute the utensils more evenly directly. in the dishwasher. Light utensils move during Arrange light utensils securely. the wash cycle. Unusual foam formation. Ha ndwash liquid in the rinse aid Immediately refill rinse aid dispenser with dispenser. rinse aid. Rinse aid spilled. Remove rinse aid with a cloth. aus Customer service 4 Customer service If you are unable to rectify the fault, please contact your customer service. We always find a suitable solution, even to avoid unnecessary visits by technicians. Contact information for your nearest customer service can be found on the back of these instructions for use or on the enclosed customer service list. When calling, please state the appliance number (E- Nr. = 1) and the production number (FD = 2) which can be found on the rating plate 9* on the appliance door. Rely on the competence of the manufa cturer. Contact us. You can therefore be sure that the repair is carried out by trained service technicians who carry original spare parts for your domestic appliances. 5 Installation and connection The dishwasher must be connected correctly, otherwise it will not function properly. The specifications for the inlet and outlet as well as the elec...
Este manual também é adequado para os modelos :Máquinas de lavar louça - SMI69M15AU/73 (2.14 mb)
Máquinas de lavar louça - SMU65M15AU/21 (2.14 mb)
Máquinas de lavar louça - SMU65M15AU/28 (2.14 mb)
Máquinas de lavar louça - SMU65M15AU/32 (2.14 mb)