Log:
Assessments - 3, GPA: 4 ( )

Instruções de Operação Haier, Modelo DW12-CBE7

Fabricante : Haier
Arquivo Tamanho: 228.49 kb
Arquivo Nome : 9a5e36aa-2f60-465a-8ec1-5c278245ca43.pdf
Língua de Ensino: en
Fotos e especificações  Haier  DW12-CBE7
Ir para baixar



Facilidade de uso


-Carefully dispose of the packing material. -After removing the packing, check to make sure that the appliance is not damaged. If in doubt, contact a qualified professional. -The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. -Fundamental rules to follow when using the appliance: * Never touch the dishwasher when barefoot or with wet hands or feet; * We discourage the use of extension cords and multiple sockets; Close-up View (control panel) * During installation, the power supply cord must not be excessively or dangerously bent or flattened; * If the appliance is not operating properly or maintenance must be performed, disconnect the appliance from the power supply. -Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. -This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. -Do not touch the heating element during or after a wash cycle. -Do not lean or sit on the door when it is open, as this could overturn the dishwasher. -If the appliance malfunctions, turn off water supply to the appliance and disconnect the plug from the wall socket. Then, consult the section entitled, "Troubleshooting". If you cannot resolve the problem, contact a service centre. -Only specialised personnel are authorised to make repairs. -Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock. F E D C B A DW12-CBE7 A ON-OFF Light D Low salt indicator light B ON-OFF Button E Low rinse aid indicator light C "HALF LOAD" Button F Cycle indicator light .1. Close-up View (Interior) GB V J L E G F I K H J L V E Upper Rack J Salt Container Cap F Top Spray Arm K Bottom Spray Arm G Rack Height Adjustor L Detergent and Rinse Aid Dispenser H Lower Rack V Third Sprayer I Washing Filter Technical characteristicsWidth 60 cm Depth 58 cm Height 82 cm Capacity 12 standard place settings Mains water pressure 0.03-0.6MPa Power voltage 220-240V~ 50Hz Total absorber power 2150W .2. Salt.. GB Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the Salt into the Softener Always use salt intended for use with dishwashers. The salt container is located beneath the lower rack and should be filled as follows: -Remove the lower rack and then unscrew and remove the cap from the salt container; -If you are filling the container for the first time, fill it with water; -Place the end of the funnel (supplied) into the hole and introduce about 2 kg of salt. It is normal for a small amount of water to come out of the salt container. -Carefully screw the cap back on. The salt container must be filled when the "low salt" indicator light (located on the control panel), comes on.. To prevent the formation of rust, load the salt just before beginning a wash cycle. Adjusting Salt Consumption The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and customize the level of salt consumption so that it remains at a minimum. To adjust salt consumption, proceed as follows: -Unscrew the cap from the salt container; -There is a ring on the container with an arrow on it (see figure to the side), -If necessary, rotate the ring in an anticlockwise direction from the "-" setting towards the "+" sign, based on the hardness of the water being used. It is recommended that adjustments be made in accordance with the following schema: Water Hardness Clarke degrees °dH mmol/l Selector position Salt consumption (Grams/cycle) Autonomy (cycles/2kg) 014 MNT MNIT L M L NQPS NUQQ NIUQIQ ?J? OM SM PSTN QRUV QIRUIV jba QM QM [TN [UV [UIV ?H? SM OR .3. Detergent and Rinse Aid.. GB Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table". The detergent dispenser is located on the inside panel the door. Loading the detergent To open the "A" cover on the dispenser, press the "B" button. The detergent for the wash cycle should be poured into the "C" compartment. After the detergent has been placed in the dispenser, close the cover and press down until it clicks in place. C B A Notice: To facilitate closing the cover, remove any excess detergent on the edges of the dispenser. Rinse Aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycles (or when the "low rinse aid" indicator light comes on for those mo...


Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias