Assessments - 3, GPA: 4.7
(
)
)
|
Facilidade de uso
- After removing the packing, check that the appliance is not damaged. If in doubt, contact a qualified professional. - The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. - Fundamental rules to follow when using the appliance: * Never touch the dishwasher when barefoot or with wet hands or feet; * We discourage the use of extension cords and multiple sockets; * During installation, the power supply cord must not be excessively or dangerously bent or flattened; Close-up View (control panel) A E D A B C ON-OFF Light Program Symbols Cycle Select Knob A B D E F E Bottom Spray Arm F Washing Filter G Detergent and Rinse Aid Dispenser H Salt Container Cap Technical characteristics Width 60 cm Depth 60 cm Height 85 cm Capacity 12 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage 220-240V~ 50Hz Total absorber power 1950W .1. .2. * If the appliance is not operating be performed, disconnect the appliance - Keep detergents out of the reach of children, kept away from the dishwasher when it - This appliance cannot be installed outdoors, area in which it is installed is covered by a roof; dangerous to leave it exposed to the rain and elements. - Do not touch the heating element during or after a wash - Do not lean or sit on the door when it is open, as this could overturn the dishwasher. - If the appliance malfunctions, turn off the water supply to the appliance and disconnect the plug from the wall socket. Then, consult the section entitled, "Troubleshooting." If you cannot solve the problem, contact a service centre. - Only specialised personnel are authorised to make repairs. - Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock. - The appliance must be positioned so that the plug is accessible. - The carpet must not obstruct the opening when the appliance is installed on a carpeted floor. - If the supply cord is damaged, it must be replaced by the manufacturer, its service agent of similarly qualified persons in order to avoid a hazard. B C D Handle For Opening Door E ON-OFF Button GB GB Salt Salt The hardness of the water varies water is used in the dishwasher, deposits and utensils. The appliance is equipped with a special softener specifically designed to eliminate lime and minerals Loading the Salt into the Softener Always use salt intended for use with dishwashers. The salt is located beneath the lower rack and should be filled follows: - Remove the lower rack and then unscrew and remove the cap from the salt container; - If you are filling the container for the first time, fill it with water; - Place the end of the funnel (supplied) into the hole and intro duce about 2 kg of salt. It is normal for a small amount of water to come out of the salt container. - Carefully screw the cap back on. To prevent the formation of rust, load the salt just before beginning a wash cycle. Adjusting Salt Consumption The dishwasher is designed to allow salt consumed according to the hardness is intended to optimise and customise the so that it remains at a minimum. To adjust salt consumption, proceed as follows: - Unscrew the cap from the salt container; - On the neck of the container there is a ring with an arrow on it (see figure above). If necessary, turn the ring anti-clockwise from the "-" sign towards the "+" setting, according to water hardness. - It is highly recommended that the following table be consulted when making adjustments. Water Hardness Clarke degrees ° dH mmol/l Selector position Salt consumption (Grams/cycle) Autonomy (cycles/2kg) M NQ M NT M NIT L M L NQ PS NU QQ NIU QIQ =?J? OM SM PS TN QR UV QIR UIV MED QM QM [TN [UV [UIV ?H? SM OR Detergent and Detergent Detergent specifically intended for be used. The dispenser must be refilled wash cycle following the instructions provided Table ". The detergent dispenser is located of the door. Loading the detergent To open cover "A" on the dispenser, press button "B". The detergent for the wash cycle should be poured into compartment "C". After the detergent has been placed in the dispenser, close the cover and press down until it clicks in place. B C A Notice: To facilitate closing the cover, remove any excess detergent on the edges of the dispenser. Rinse Aid This product makes dishes sparkle without spotting. The dispenser is panel of the door and should be filled cycles. Loading the Rinse Aid To open the dispenser, turn cap "C" anticlockwise add the rinse aid, making sure not to overfill. The amount of rinse aid used for each cycle can be regulated by turning dose adjuster "F", located beneath cap "C", with a screwdriver. There are 6 different settings; the normal dosage setting is 3. Important: Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, the dosage adjuster should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjus...