Contents Electrical Connection For Your Safety Installation Getting to know your Dishwasher The Controls How to use your Dishwasher Programme Chart Before Using your Dishwasher Loading your Dishwasher Care and Cleaning Troubleshooting Information for Test Labs After Sales Service Hotpoint Guarantee Notes Key Contacts 4 5 6 7 7 8 9 10-11 12 13 14 15 16 17 18-19 Back Cover Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains important details on

2. The door is securely closed. 3. You have selected a programme and switched on. 4. The water supply is turned on. 5. The inlet hose Is not kinked. 6. The fuses in the plug and main fuse box are OK. Try plugging in another appliance to check. If the fuse has blown refer to Electrical Requirements on page 22 of the Installation Instructions. It won’t fill Make sure that: 1. You have not forgotten to turn on the tap. 2. The inlet hose Is not kinked. It won’t empty Make sure that: 1. The drain h

2. Reposition the ‘Hooked End Support’ as required along the GREY drainage hose. 3. If fitting an under sink waste disposal unit, cut out the membrane, bung or blanking plug. 4. Attach the GREY drainage hose to the under sink waste disposal unit securely, using the clip and rubber tube supplied. Ensure the drain hose is securely attached, to prevent it coming away while the machine is in use and causing a flood. D ISHWASHE. Getting to know your Dishwasher E. Upper basket I. Bottom spray arm F. T

D ISHWASHE. For your Safety This manual forms an integral part of the appliance. It must always be kept handy for reference. Read through all the instructions contained in this manual before using the dishwasher. Installation must be performed by a qualified technician, in compliance with the regulations in force, including the prevention and elimination of radio frequency interference. The dishwasher is designed for washing and drying dishes, anyother use shall be considered improper. The manuf

D ISHWASHE. Installation Choose where you want to install your dishwasher, you can place it so that its sides or back panel are side by side with furniture or up against the wall. The dishwasher is provided with water supply and drain hoses, which can be directed towards the left or right to facilitate appropriate installation. Levelling. Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and to level it so that it is horizontal. Make s

Ensure the drain hose is securely attached, to prevent it coming away while the machine is in use and causing a flood. D ISHWASHE. Getting to know your Dishwasher E. Upper basket F. Top spray arm G. Basket height adjuster H. Lower basket The Controls A. ON-OFF Button Press this button to turn the appliance on. C. Door opening handle Use this handle to open the dishwasher door. D. Display (LCD) Buttons and indicator lights toprogram the appliance. G. Cycle phase indicator light (pre-wash, wash, r

Use a screwdriver to turn the screws in the clockwise or anti-clockwise direction to increase or decrease the height respectively. Adjusting the back Feet Insert the appliance into the cutout and then adjust the height using the screws located on the front bottom part of the machine. Use a screwdriver to turn the screws in the clockwise or anti-clockwise direction to increase or decrease the height respectively. Condensation-proof tape. On some models, a transparent condensation-proof adhesive t

. This will prevent the pipe from jumping out during installation and use. DO NOT position the standpipe near an electrical outlet. ENSURE that the drain hose is not kinked and it is routed as shown in the diagram. The standpipe should have a bore of at least 38mm (11/2”). It should be installed as shown, have a trap fitted and must discharge into the same drain system as your household sink. It MUST NOT be connected to a surface water drain. Sink Waste System: For under sink drainage: Before co

. . . . . ........2 Howtotest water . . . . ........2 Using a rinse agent . . . ........2 How to choose and use the right detergent. . . . . . . . . . ..2 How to prepare dishes forwashing . . . . . . . . . . . . . . . . .3 How to load your dishwasher. . . . . . . . . . . .. ...4.5 What can you wash safely. .. ...6 How to connect electricity on convertible models. .. ......7 How to connect the Unicouple on convertible models . . . ........8 User maintenance instructions . . . . . . . . . .. .....

Step 4: Select wash programme as normal. Please Note: If the above does not solve the problem, check that the water feed pipe filter is not blocked. “END” will flash in the display at one-second intervals to indicate the programme is complete & the machine is in standby mode. -Press & hold the “On/Off” button to switch off the dishwasher. Please Note: When your dishwasher is switched back on, “END” will continue to flash in the display until a new programme is selected – This is normal. Fault Ar