|
Facilidade de uso
1 Form No. GRM-0707 IMPORTANT SAFETY INFORMATION CAUTIONS Standard and approved manufacturing oils will smoke up to 30 minutes during initial start-up. This is a temporary condition. To assure safe operation, operate unit without food product until smoke dissipates. Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. To prevent unit failure do not add a decorative soffit to hide a pass-through mounted Glo-Ray Strip Heater. Strip Heaters with incandescent lights that require a circuit breaker larger than 20 amps must have a separate circuit breaker for the incandescent lights that is 20 amps or less. To assure safe and proper operation refer to Installation Clearance Requirements listed in this manual. Installation of two or more single units with less than 3" (76 mm) between housings may result in premature failure of component parts. Unit is not moisture proof. Spacing of at least 16" (406 mm) is required for all units mounted over a steam table. MODEL DESIGNATION NOTICE Use only non-abrasive cleaners. Abrasive cleaners could scratch the finish of your unit, marring its appearance and making it susceptible to dirt accumulation. To prevent premature failure to components the Remote Control Box (RMB) must be installed outside the strip heater heat zone. Heat damage to countertop material such as Corian® and similar products (other than stainless steel) is not covered under the Hatco warranty. Contact the manufacturer of the base material for temperature limits and application information before installing the unit. GRA H L-24 D GLO-RAY Dual Strip Heater Housing Type Length in InchesA-Aluminum Incandescent Light N-Narrow Powder-Coated Steel No Character-Stainless Steel Housing High Wattage Figure 1. Model Designation Form No. GRM-0707 2 Hatco Glo-Ray® Infrared Strip Heater keep hot foods at optimum serving temperatures longer. Foods do not dry out or become discolored; even the most delicate dishes hold that “just-prepared” look. The Glo-Ray pre-focused heat pattern directs heat from a tubular element to bathe the entire holding surface. Hatco Glo-Ray® Strip Heater can be ordered in standard or high wattage configurations, aluminum housings in lengths of 18" (457 mm) to 144" (3658 mm), stainless steel housings in lengths of 24" (610 mm) to 96" (2438 mm) or narrow design housings in lengths of 18" (457 mm) to 72" (1829 mm). All Strip Heaters have several mounting options and switch locations. Optional infinite control switches, remote control enclosures, incandescent lighting and breath protectors are available. The Glo-Ray dual models allow for side by side mounting of two or more strip heaters installed (with a required 3" (76 mm) or 6" (152 mm) spacer), to provide a wider holding area. 3 Form No. GRM-0707 MODEL DESCRIPTIONS Figure 2. GRA-24 Model CAUTION - HOT GLO-RAY Foodwarmer HATCO CORP. MILWAUKEE, WI U.S.A. ON OFFO PARTS & SERVICE ASSISTANCE WWW.HATCOCORP.COM 800-558-0607 Figure 3. GRAHL-24 Model CAUTION - HOT GLO-RAY Foodwarmer HATCO CORP. MILWAUKEE, WI U.S.A. ON OFFO PARTS & SERVICE ASSISTANCE WWW.HATCOCORP.COM 800-558-0607 Figure 4. GRA-24D Model CAUTION - HOT GLO-RAY Foodwarmer HATCO CORP. MILWAUKEE, WI U.S.A. ON OFF O PARTS & SERVICE ASSISTANCE WWW.HAT COCORP.COM 800-558-0607 Figure 5. GRN-24 Model GR-XX: Stainless steel housing, standard wattage GRH-XX: Stainless steel housing, high wattage GRN-XX: Narrow design, powder-coated painted steel housing, standard wattage GRNH-XX: Narrow design, powder-coated painted steel housing, high wattage NOTE: Stainless steel and narrow design Strip Heaters are not available with lights, breath protectors or as dual units. GRA-XX: Aluminum housing, standard wattage GRAH-XX: Aluminum housing, high wattage GRAL-XX: Aluminum housing, standard wattage, incandescent light GRAHL-XX: Aluminum housing, high wattage, incandescent light GRA-XXD: Aluminum housing, standard wattage, dual GRAH-XXD: Aluminum housing, high wattage, dual GRAL-XXD: Aluminum housing, standard wattage, incandescent light, dual GRAHL-XXD:Aluminum housing, high wattage, incandescent light, dual NOTE: Incandescent lights and breath protectors not available for retro-fit. SPECIFICATIONS GR MODELS-ELECTRICAL RATING CHART GRH MODELS-ELECTRICAL RATING CHART Model GR-18 Watts: 250 Shipping Weight: 7 lbs. (3 kg) Model GRH-18 Watts: 350 Shipping Weight: 7 lbs. (3 kg) Voltage 120 208 240 100 200 220• 240• Voltage 120 208 240 100 200 220• 240• Amps 2.1 1.2 1.0 2.5 1.3 1.1 1.0 Amps 2.9 1.7 1.5 3.5 1.8 1.6 1.5 Model GR-24 Watts: 350 Shipping Weight: 7 lbs. (3 kg) Model GRH-24 Watts: 500 Shipping Weight: 7 lbs. (3 kg) Voltage 120 208 240 100 200 220• 240• Voltage 120 208 240 100 200 220• 240• Amps 2.9 1.7 1.5 3.5 1.8 1.6 1.5 Amps 4.2 2.4 2.1 5.0 2.5 2.3 2.1 Model GR-36 Watts: 575 Shipping Weight: 10 lbs. (5 kg) Model GRH-36 Watts: 800 Shipping Weight: 10 lbs. (5 kg) Voltage 120 208 240 100 200 220• 240• Voltage 120 208 240 100 200 220• 240• Amps 4.8 2.7 2.4 5.8 ...
Este manual também é adequado para os modelos :Impressoras - GLO-RAY GRA (425.8 kb)
Impressoras - GLO-RAY GR (425.8 kb)
Impressoras - GLO-RAY GRAH (425.8 kb)
Impressoras - GLO-RAY GRAL (425.8 kb)