Assessments - 4, GPA: 3.8
(
)
)
|
Facilidade de uso
The marks are on the water level gauge (5). . Close the lid by pressing the button for closing the lid (9) and make sure it clicks into place. o Caution! If the lid is not correctly closed, the appliance does not automatically switch off, once the water boils. 4. Place the kettle on its base ( ) by positioning it so the stud on the base (4) fits into the hole on the underside of the kettle. 5. Insert the plug ( ) in the mains socket and switch on the power. o Caution! If you set the on/off switch ( 2) to the "I" position before replacing the kettle on the base, the kettle switches on automatically when replaced on the base. For safety’s sake, check the on/off switch position before replacing the kettle on the base to avoid accidentally starting the kettle. 6. Switch on the appliance by switching the on/off button forward to "I". The kettle will begin to heat the water. o If you want to interrupt the boiling, you can do this at any time by switching the on/off button to position "0". o Once the water is boiling, the kettle will automatically switch off thanks to the integrated thermostat. The on/off button automatically returns to position “0”. Anti boil-dry device If you switch the kettle on without having filled it with water, or when the water level is below the “MIN” mark, the anti boil-dry device will automatically switch it off. The kettle can be switched on normally as soon as it is filled with a sufficient amount of water. Storage • The cord can be wound round the holder (2) at the bottom of the base. • Ensure the appliance is clean and dry before storing. CLEANING When cleaning the appliance, you should pay attention to the following points: • Remove the plug from the wall socket and allow the appliance to cool down before cleaning. • Do not immerse in water or any other liquid. • Clean the appliance by wiping it with a damp cloth. A little detergent can be added if the appliance is heavily soiled. • Never use a scouring pad, steel wool or any form of strong solvents or abrasive cleaning agents to clean the appliance, as those may damage the outside surfaces of the appliance. • Make sure that no water gets into the connector on the base or the hole in the underside of the kettle. • Remove the limescale filter (10) from the appliance and gently clean it with a soft brush. Remove the filter by pulling it upwards and out of the holder. You can insert your finger through the spout (11) and gently press the filter to loosen its lower part. Replace the filter in the appliance after cleaning. 5 55 Descaling The lime content of ordinary tap water means limescale may gradually be deposited inside the appliance. This limescale may be loosened using acetic acid (NOT ordinary vinegar) or descaler, available in supermarkets, etc. . Mix 00 ml acetic acid with 00 ml cold water, or follow the instructions on the descaler packaging. 2. Pour the solution into the kettle and switch it on. . Allow the solution to boil twice and then pour it out. 4. To remove the final residues of limescale and acetic acid, pour cold water into the kettle again (up to the "MAX" mark) and switch it on. 5. Pour out the water once it has boiled. 6. Repeat points 4-5, three times. The appliance is now ready for use. INFORMATION ON DISPOSAL AND RECYCLING OF THIS PRODUCT Please note that this Adexi product is marked with this symbol: This means that this product must not be disposed of together with ordinary household waste, as electrical and electronic waste must be disposed of separately. In accordance with the WEEE directive, every member state must ensure correct collection, recovery, handling and recycling of electrical and electronic waste. Private households in the EU can take used equipment to special recycling stations free of charge. In certain member states, used appliances can be returned to the dealer where they were bought on the condition you buy new products. Contact your retailer, distributor or the municipal authorities for further information on what you should do with electrical and electronic waste. GUARANTEE TERMS The guarantee does not apply: • if the above instructions are not followed • if the appliance has been interfered with • if the appliance has been mishandled, subjected to rough treatment, or has suffered any other form of damage • if faults have arisen because of faults in your electricity supply. Due to the constant development of our products in terms of function and design, we reserve the right to make changes to the product without prior warning. QUESTIONS AND ANSWERS If you have any questions regarding use of the appliance and cannot find the answer in this user guide, please try our website at Go to the "Consumer Service" menu, click on "Question & Answer" to see the most frequently asked questions. You can also see contact details if you need to contact us for technical issues, repairs, accessories and spare parts. IMPORTER Adexi Group We cannot be held responsible for any pri...