Assessments - 2, GPA: 4.5 ( )

Fabricante : Oster Arquivo Tamanho: 661.55 kb Arquivo Nome : Língua de Ensino:

6. Fill the pitcher with ice cubes to the ice level marked on the pitcher. If you are low on ice, you may substitute cold water, refilling the pitcher to the WATER level marked on the pitcher. DO NOT fill to the ice level as this will cause an overflow when the tea brews. 7. Slide the pitcher towards the iced tea maker and rest flush against the appliance. NOTE: Make sure the rotating brew head is centered over the pitcher before turning on the iced tea maker. 8. Turn the iced tea maker on by plugging the power cord into an electrical outlet and pushing the “on” button firmly until the ON indicator light is illuminated. 9. When the brewing cycle is complete, the iced tea maker will shut off automatically. Wait 30 seconds, then slide the pitcher away from the appliance and serve your iced tea. Your tea may turn cloudy as it chills due to the presence of naturally occurring tannic acids found in tea. 10. After you are done enjoying your iced tea beverage, wait for the iced tea maker contents to cool down before handling. Then open the lid, rotate the shower head out of the way and remove brew basket. Discard the contents and rinse it with clean water. Max Figure 1 Figure 2 CLEANING AND MAINTAINING YOUR ICED TEA MAKER Cleaning your Oster® Iced Tea Maker Turn off and unplug cord. Clean only with a damp cloth. Hard water can leave mineral deposits inside the pitcher and the brew basket. To remove these, fill the brew basket and the pitcher with warm, undiluted white household vinegar. Let soak for 20 minutes, then rinse. Never use harsh, abrasive cleansers, steel wool pads or other abrasive materials. They may cause scratches which can lead to breakage. CAUTION! Never immerse the iced tea maker itself in water, in any other liquid or in the dishwasher. Decalcifying your Oster® Iced Tea Maker Mineral (calcium/limestone) found in the water will leave deposits in your iced tea maker and will affect its performance. If you notice an increase in steaming or if the pumping action stops before all of the water has been pumped out of the appliance, it’s time to clean it. The frequency of cleaning depends on the hardness (mineral content) of your tap water. Please see the following chart: Suggested Cleaning Interval Type of Water Cleaning Frequency Soft Water Every 80 Brew Cycles Hard Water Every 40 Brew Cycles It’s recommended that you regularly remove mineral deposits by using undiluted, white household vinegar. 1. Pour one quart of undiluted, white household vinegar into the water reservoir. 2. Place the pitcher lid on the pitcher and slide the pitcher into place under the Rotating Brew Head. 3. Push the “on” button to begin the brewing cycle. After one cup of vinegar has pumped into the pitcher, unplug the iced tea maker. Let it stand for 30 minutes. 4. Plug in the iced tea maker again. Continue brewing process again to pump out the remaining cleaner or vinegar. 5. When the iced tea maker shuts off, unplug it, remove the pitcher and discard the cleaning solution. 6. Fill the pitcher with clean tap water to the water level marked on the pitcher and repeat Steps 1-5 without the cleaning solution. Repeat this process if necessary. 7 8 BVST_TM20_09ESM1.qxd:Layout 1 4/21/09 10:53 AM Page 9 SERVICE Replacement Parts • Pitchers – Please call 1-800-334-0759 in the U.S. or 1-800-667-8623 in Canada for information on where you can find a store that carries replacement pitchers or visit IF YOUR ICED TEA MAKER REQUIRES SERVICE, DO NOT RETURN IT TO THE STORE WHERE YOU PURCHASED IT. All repairs must be made by Sunbeam or by an authorized Oster® Service Center. If you live in the U.S. or Canada, please call us at the following toll-free telephone numbers to find the location of the nearest authorized service center: U.S. 1-800-334-0759 Canada 1-800-667-8623 You may also visit our website at for a list of service centers. To assist us in serving you, please have the iced tea maker model number and date of purchase available when you call. We welcome your questions, comments or suggestions. In all your communications, please include your complete name, address and telephone number and a description of the problem. 1 Year Limited Warranty Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions (collectively “JCS”) warrants that for a period of one year from the date of purchase, this product will be free from defects in material and workmanship. JCS, at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available, replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. Doing so wil...

Baixe o seu

Para fazer o download, introduza 2 dígitos :