Assessments - 1, GPA: 5
(
)
)
|
Facilidade de uso
Consult floor plans on pages 8-10 for positioning and related information. See pages 11-13 for wiring diagrams. Hobart CG Series Electric Counter Griddles are heavy duty griddles capable of handling any griddling operation with ease. Included are large grease drawers which pull out from the front. INSTALLATION Before installing the griddle, verify that the electrical supply agrees with the specifications on the griddle data plate which is located on the top right side of the griddle body. UNPACKING Immediately after unpacking the griddle, check for possible shipping damage. If the griddle is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery. ASSEMBLY Place the griddle on its back. Attach the four 4" legs (eight 4" legs on Model CG59 ) to the body of the griddle by threading the exposed leg stud into the threaded holes located on the underside of the griddle. Tighten each leg so that the top face of the leg is pressed firmly against the body bottom. LOCATION Place the griddle in its operating location. Allow adequate space around the griddle for operation and servicing. LEVELING Level the griddle front-to-back and side-to-side. Hold the leg with one hand to prevent the leg from loosening from the body and use a wrench to turn the foot to increase or decrease leg height. – 5 – INSTALLATION CODES AND STANDARDS Your Hobart griddle should be installed in accordance with: In the United States 1. State and local codes. 2. National Electrical Code ANSI/NFPA 70 (latest edition). In Canada: 1. Local codes. 2. Canadian Electrical Code Part 1 CSA-C22.1 (latest edition). ELECTRICAL CONNECTIONS WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES. WARNING: DISCONNECT ELECTRICAL SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT. Standard Electrical Connections 1. Remove the small cover plate on the back of the griddle. This exposes the built-in terminal box and line leads. 2. Select a suitable knockout on the rear or bottom of the terminal box. 3. Connect the line leads to the supply wires (refer to the wiring diagram). 4. Push the excess wire into the terminal box and replace the cover plate. Close Back Wall, Rigid Conduit Electrical Connections If the griddle is to be installed close to a back wall and rigid condit is to be used, follow this procedure: 1. Lift front of griddle top only as far as necessary to gain access to the terminal box on the body's inside rear. 2. Prop the griddle top up securely to prevent it from falling down...
Este manual também é adequado para os modelos :Outros aparelhos de cozinha - CG50 ML-114582BN41 ML-CG41208S001 (1.12 mb)
Outros aparelhos de cozinha - CG41 ML-CG41208S001 (1.12 mb)
Outros aparelhos de cozinha - CG20 ML-43120 (1.12 mb)
Outros aparelhos de cozinha - CG20 ML-CG20480S001 (1.12 mb)