Assessments - 1, GPA: 3 ( )

Fabricante : Dacor Arquivo Tamanho: 418.87 kb Arquivo Nome : Língua de Ensino:

(610 mm) Installation Specifications Installation Specifications Install a Support Platform in the Cabinet Provide a platform (100 lb. load capacity) within the cabinet upon which the warming drawer will be supported. The platform must be installed level and straight. The top edge of the platform must be flush with the cutout at the front of the cabinet. There are no provisions to level the warming drawer after it has been installed. 3/4” (19 mm) thick plywood is recommended. NOtE: If the drawer is not installed in a level fashion, the drawer may slide open on its own or may not seal tightly, allowing heat to escape and resulting in poor warming drawer performance. SupportplatformChassisface Electrical Power Supply Requirements • The warming drawer is supplied with a power cord terminated by a three-prong plug. Plug it directly into a dedicated, grounded, three prong, electrical outlet. Do not use an extension cord. Three-Prong Three-Prong Plug Grounded Outlet • The correct voltage, frequency and amperage must be supplied to the electrical outlet from a grounded, single phase circuit that is protected by a properly sized circuit breaker or time-delay fuse. • The required voltage, frequency and amperage ratings are listed on the appliance data plate. The data plate is located inside the chassis drawer opening on the left side. Remove the drawer to expose it. Nominal Electrical Supply Requirements 120 Vac, 60 Hz, 15 Amp. dedicated circuit The warming drawer is supplied with a 40” (1016 mm) power cord with a three prong grounded plug. total Connected Load 0.5 kW (4 Amp.) • If the power supply requirements shown above do not agree with those listed on the product data plate, use the requirements on the product data plate. • It is the owner’s responsibility to ensure that the electrical outlet is installed by a qualified electrician. The electrical installation must comply with the latest revision of the National Electric Code ANSI/NFPA 70 and local codes and ordinances. • If the electrical service provided does not meet the product specification, or does not conform to the NEC or local standards, do not proceed with the installation. Call a licensed electrician to correct the electrical service before proceeding. • Be certain to locate the electrical outlet in an accessible location, so that the warming drawer may be easily unplugged in the event that service becomes necessary. Installation Instructions Installation Instructions WARNING • • • To avoid personal injury caused by the appliance falling forward when the drawer is opened, secure the chassis to the cabinet and support platform as instructed. Be certain that the power plug is disconnected from the electrical outlet before installation. Verify that the electrical supply matches the ratings found on the appliance data plate and the installation specifications before proceeding. Remove the Drawer Remove the drawer from the appliance to allow access to the mounting holes during installation, and...

Baixe o seu

Para fazer o download, introduza 2 dígitos :