Assessments - 4, GPA: 3.5 ( )

Fabricante : GE Arquivo Tamanho: 714.37 kb Arquivo Nome : Língua de Ensino:

• Electrical Ground is REQUIRED on this compactor. • DO NOT ground to a gas pipe. • DO NOT change the power supply cord plug. If it does not fit the outlet, have a proper outlet installed by a qualified electrician. • DO NOT have a fuse in the neutral or grounding circuit. A fuse in the neutral or grounding circuit could result in an electrical shock. • DO NOT use an extension cord with this compactor. Failure to follow these instructions could result in death or serious injury. Recommended Grounding Method: For your personal safety, this appliance must be grounded. This appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong grounding type wall receptacle, grounded in accordance with the National Electrical Code ANSI/NFPA70—latest edition* and all local codes and ordinances. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have a properly grounded 3-prong wall receptacle installed by a qualified electrician. 3-prong grounding-type wall receptacle Copies of the standards listed may be obtained from: * National Fire Protection Association Batterymarch Park, Quincy, MA 02260 3-prong grounding plug Grounding plug Power supply cord 5 Installation Preparation 6 1 UNPACKING THE COMPACTOR • Move the compactor close to the installation location. • Use a section of the shipping carton to protect the finished floor. • Do not use the handle to lift the compactor. • Remove all protective packaging materials such as tape or shipping pads. Remove waxy residue caused by shipping material with a mild solution of liquid household cleaner and water. • Check that the power supply cord is attached to the cord clip on the rear of the compactor. IMPORTANT: Use the shipping carton as a pad. Do not slide the compactor across a finished floor. Damage will occur. Cord clip UNPACKING THE COMPACTOR (CONT.) • Open the compactor drawer and remove any shipping materials or other items shipped in the drawer. • Do not remove the compactor bag (if installed). • Grasp the sides of the drawer and lift it out of the compactor. Place the drawer on a protected surface. The drawer can scratch a finished floor. 7 Installation Preparation 2 LEVELING THE COMPACTOR • The top of the compactor should be at least 1/8. (3 mm) from the top of the cabinet opening. You can adjust the height of the compactor by turning the screws on the front leveling legs and rear wheels. • Place a level inside the compactor on the floor of the cabinet. • Use the leveling legs to adjust level front to back and side to side. Front leveling legs Rear wheels ADJUST THE RETAINING BRACKET 3 • Determine installation depth of the compactor beneath the countertop. • Adjust the position of the retaining brackets so that the screws can meet the underside of the countertop. • Mounting clips are provided for stone or other hard countertops that will not acc...

Baixe o seu

Para fazer o download, introduza 2 dígitos :