Assessments - 2, GPA: 4.5
(
)
)
|
Facilidade de uso
c. LP gas in its natural state has no odor. For your safety, an odorant is added that smells like rotten cabbage. d. Contact with LP gas can cause freeze burns to skin. 7. LP gas tank needed to operate. Only tanks marked “propane” may be used. a. The LP gas supply tank must be constructed and marked in accordance with the Specifications for LP gas Cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339, Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods; and Commission. b. LP gas tank must be arranged for vapor withdrawal. c. The LP gas tank must have a listed overfilling prevention device (OPD). d. Only use 20-pound cylinders equipped with a cylinder connection device compatible with the connection for outdoor cooking appliances. e. The LP gas tank must have a tank collar to protect the tank valve. f. Never use an LP gas tank with a damaged body, valve, collar, or footing. g. Dented or rusted LP gas tanks may be hazardous and should be checked by your LP gas supplier prior to use. h. The LP gas tank should not be dropped or handled roughly. i. Tanks must be stored outdoors out of the reach of children and must not be stored in a building, garage, or any other enclosed area. Your tank must never be stored where temperatures can reach over 125°F. j. Never keep a filled LP gas tank in a hot car or car trunk. Heat will cause the gas pressure to increase, which may open the relief valve and allow gas to escape. k. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane. l. Do not store a spare LP gas tank under or near this appliance. m. Never fill the tank beyond 80 percent full. n. A fire causing, serious injury or damage to property may occur if the above is not followed exactly. o. Always transport your tank in a secure, well-ventilated location in your vehicle. LP gas tank should be upright with valve turned off. LP gas tank should be taken directly to and from place of use. 8. Never attempt to attach this SkeeterVac® to the self-contained LP gas system of a camper trailer, motor home, or house. 9. The use of alcohol, or prescription or non-prescription drugs may impair the consumer’s ability to properly assemble or safely operate the appliance. 10. Your SkeeterVac® has been checked at all factory connections for leaks. Recheck all connections, as movement in shipping can loosen connections. 11. Check for leaks even if your unit was assembled for you by someone else. 12. Do not operate if gas leak is present. Gas leaks may cause a fire or explosion. 13. You must follow all leak-checking procedures before operating. To prevent fire or explosion hazard when testing for a leak: a. Always perform leak test before lighting the SkeeterVac® and each time the tank is connected for use. b. No smoking. Do not use or permit sources of ignition in the area while conducting a leak test. c. Conduct the leak test outdoors in a well-ventilated area. d. Do not use matches, lighters, or a flame to check for leaks. e. Do not use SkeeterVac® until any and all leaks are corrected. If you are unable to stop a leak, disconnect the LP gas supply. Call a gas appliance serviceman or your local LP gas supplier. 14. Do not store or use gasoline or other flammable liquids or vapors within 25 feet (7.62 m) of this appliance. 15. Do not use in an explosive atmosphere. Keep SkeeterVac® area clear and free from combustible materials, gasoline and other flammable vapors and liquids. 16. Minimum clearance from sides and back of unit to combustible construction, 21 inches from side and 21 inches from back. Do not use this appliance under overhead combustible surfaces. 17. It is essential to keep the SkeeterVac®’s valve compartment, burners, and circulating air passages clean. Inspect SkeeterVac® before each use. 18. Do not alter SkeeterVac® in any manner. 19. Do not use the SkeeterVac® unless it is COMPLETELY assembled and all parts are securely fastened and tightened. 20. This SkeeterVac® should be thoroughly cleaned and inspected on a regular basis. Clean and inspect the hose before each use of the appliance. If there is evidence of abrasion, wear, cuts, or leaks, the hose must be replaced prior to the appliance being put into operation. 21. Use only the regulator and hose assembly provided. The replacement regulator and hose assembly shall be that specified by the manufacturer. 22. Use only Blue Rhino Global Sourcing, LLC. factory authorized parts. The use of any part that is not factory authorized can be dangerous. This will also void your warranty. 23. Do not use this appliance without reading “Operating Instructions” in this manual. 24. Do not install or use in or on boats or recreational vehicles. 25. Product performance can vary due to weather, wind and other environmental conditi...