Assessments - 2, GPA: 4
(
)
)
|
Facilidade de uso
If you are unable to understand the warnings, cautions or instructions, contact a healthcare professional, dealer or technical personnel before attempting to use this equipment - otherwise, injury or damage may occur. The disinfectant dispensing system has been factory tested and calibrated for use with Invacare disinfectant. The use of any disinfectant with a dilution ratio (. oz. per gallon) or viscosity level different than that of Invacare disinfectant will result in an improper mixture of disinfectant and water. This may cause your system to be improperly disinfected - or in some instances, not disinfected at all. If using any disinfectant with a dilution ratio or viscosity level different than that of Invacare disinfectant or if switching from one type of disinfectant to another type, the disinfectant flowmeter must be calibrated before performing this procedure. Refer to the tub owner’s manual or to the calibration instruction sheet, part number 1154272, for the calibration procedure. ALWAYS wear rubber gloves, an apron and face shield protection during disinfecting, cleaning and rinsing procedures. In case of eye or skin contact, follow procedures on disinfectant container. CAUTION NEVER use abrasive cleaners like scouring powder or liquid cleaners containing pumice stone. The use of these types of cleaners will make the gel-coat finish of your tub scratched and dull. NEVER use cleaners containing iodine, bromine, Betadine® or methylene blue. The use of these types of cleaners will cause the tub to stain. Never use cleaners containing bleach. Use of these types of cleaners will dry out the rubber seals and gaskets and the tub will not function properly. Before starting the whirlpool pump, the water level must be completely above the whirlpool jets. Otherwise damage to the motor/pump will result. Heavy Duty Cleaning Procedure In additionto disinfecting yourtubafter every use, youwill need to performthis procedureapproximately once every 80.150 baths. 1. Clean the entire surface of the tub to remove visible tissue residue and fluid. 2. Rinse the inside surface of the tub with the shower/massage wand on the spray setting. 3. Rotate the water temperature valve to adjust the water temperature to approximately 105o F. NOTE: This will maximize the cleaning solution.s ability to clean and disinfect the system. 4. Close the drain. 5. Make sure the whirlpool jets are open. 6. Fill the tub one inch above the highest whirlpool jets. 7. Add the Invacare Heavy Duty Cleaner to the water in the tub. Refer to the chart for the proper amount. 8. Spray pre.mixed Invacare Heavy Duty Cleaner on the remaining surfaces. 9. Press the whirlpool on/off button to turn on the whirlpool pump and let the pump runfor 60 seconds. 10. Turnoffthepumpandallowtheheavydutycleaner/watersolutiontoremaininthetubfor 10 minutes. 11. During this ten.minute waiting time, take a long handled brush and thoroughly scruball interior surfaces of the tub. 12. Open the drain to allow the ...
Este manual também é adequado para os modelos :Outros acessórios para a casa - 2001 (158.96 kb)
Outros acessórios para a casa - 2300 (158.96 kb)
Outros acessórios para a casa - 2800 (158.96 kb)
Outros acessórios para a casa - 3300 (158.96 kb)