THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR LANTERNS. WHEN YOU SEE THE SAFETY ALERT SYMBOL, PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY WARNINGS & INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR GARDEN LANTERNS. WARNING • • • • • • • • • • • • • • • Proper clearance between garden lanterns and combustible material (bushes, trees, wooden decks, fences, buildings, etc.) or construction s

• A damaged battery can leak acid. Avoid contact with eyes and skin. If contact occurs, flush immediately with large amounts of water. DO NOT ingest. If contact with eyes or ingestion occurs, consult physician immediately. USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR SPOTLIGHT. FAILURE TO ADHERE TO THE SAFETY WARNINGS AND GUIDELINES IN THIS MANUAL COULD RESULT IN BODILY INJURY OR PROPERTY DAMAGE. SAVE THIS MANUAL FOR FUTURE REFERENCE. INSTR-800-2200-0_Dual Xenon.qxd 6/24/03 3:23 PM Page 3 OP

Step 3 Insert light head into ground stake. The photocell light sensor should point away from other nighttime light sources. Step 4 Charge in direct sunlight for 10-12 FULL, SUNNY DAYS. The light will turn on automatically at night. Allow at least 10-12 cycles (i.e., 10-12 days and nights of charging and discharging) for the battery to charge to its full capacity. Deck/Wall/FenceMounting: Select a location with full, direct sunlight. Shady locations will not allow the battery to charge fully and

• Other light sources: If your solar lights are located too close to a street light, porch light or another solar light, it may not turn on automatically at night. The built-in photocell light sensor is reacting to the other light source. Eliminate the other light source or relocate your solar lights. • Dirty solar panel: A dirty solar panel will not allow the battery to fully charge. This will shorten the life of the battery and cause the light to malfunction. Clean regularly with a dampened cl

SAVE THIS MANUAL FOR FUTURE REFERENCE. Step 1 Attach the ground stake to a pointed connector. Push approximately 3" of the ground stake into the ground. If the ground is too hard, soak area with water to soften. Step 2 Align the connector to the grooves on bottom of light head. Turn counter-clockwise to set in place. Step 3 Insert light head into ground stake. The photocell light sensor should point away from other nighttime light sources. Step 4 Charge in direct sunlight for 10-12 FULL, SUNNY D

At night, the light turns on automatically using the electricity stored during that day. The number of hours the light will stay on is dependent on your geographical location, weather conditions and seasonal lighting availability. Solar lights do not receive as much direct sunlight in winter months. Therefore, the number of hours the light will stay on will be reduced during winter. BEFORE FIRST USE – Pull out to remove the clear plastic strip with orange sticker in the light fixture to charge b

Therefore, the number of hours the light will stay on will be reduced during winter. 1 BEFORE FIRST USE – Pull out to remove the clear plastic strip with orange sticker in the light fixture to charge batteries. Your new solar light’s rechargeable Ni-Cd battery is fully charged and ready for use. Install the solar light in direct sunlight. For optimum performance, it is best to charge the solar light for a FULL, SUNNY DAY. The light will turn on automatically at night. The Ni-Cd rechargeable batt

A dirty solar panel will not allow the battery to fully charge. This will shorten the life of the battery and cause the light to malfunction. Clean regularly with a dampened cloth or paper towel. Solar lights can be left outside year round, even in cold weather. However, if you wish to store your light indoors for more than two or three days, follow these steps to prevent damage to rechargeable batteries: • Store at room temperature in a dry location. • Store solar light where it can receive som

GARDEN ACCENT LIGHTS LEGACY™ & HAMPTON™ OWNER’S MANUAL ASSEMBLY AND OPERATING INSTRUCTIONS HOW YOUR LEGACY™ & HAMPTON™ SOLAR-POWERED L.E.D. LIGHTS WORK READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING YOUR SOLAR LIGHT. SAVE THIS MANUAL FOR FUTURE REFERENCE. IMPORTANT: The EPA Certified RBRC® Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery contained in our product indicates The Brinkmann Corporation is voluntarily participating in an industry program to collect and recycle

The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERY™ for information on Ni-Cd battery recycling and disposal bans/restrictions in your area. The Brinkmann Corporation’s involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. Top Housing Tabs Lens Battery Compartment Lids Batteries Top Housing