Assessments - 5, GPA: 5
(
)
)
|
Facilidade de uso
Model Number: Model Description: *Product you purchased may vary from picture shown* CAUTION: Read and follow all Safety Rules and Operating Instructions of this product. Retain this document for future reference. Sears, Roebuck and Co., Hoffman Estates, IL 60179 USA • DO NOT stand on this product. You may fall which may cause personal injury. • WEAR SAFETY GLASSES AND GLOVES when cutting the banding material. The bands may snap which may cause personal injury. • WEAR SAFETY GLASSES when removing or repositioning the slides. The tool could slip which may cause personal injury. • When moving this product, do not pull it. Push the product to prevent personal injury. • Handle and swivel casters must be attached on the same side of the product. • USE THE BRAKES when not moving this product. This will prevent the product from rolling, which may cause personal injury or product damage. • BE CAREFUL when opening more than one drawer. The product may become unstable and tip, which may cause personal injury or product damage. • DO NOT step in the drawers. You may fall which may cause personal injury. • Appropriately secure this product before moving it with a forklift. • DO NOT tow with power equipment. The product could tip, which may cause personal injury or product damage. • DO NOT alter this product in any manner. For example, do not weld external lockbars or attach electrical equipment. This may cause product damage or personal injury. • Keep the product on level surfaces. The product may become unstable and tip if stored or moved on an un-level surface, which may cause personal injury or product damage. • Lock the drawers and doors before moving this product. The drawers or doors could come open and make the product unstable and tip, which may cause personal injury or product damage. • When the cover is opened, be sure the cover stop is in the locked position. This will prevent accidental closure and personal injury. • BE CAREFUL when closing the cover. Remove hands before the cover closes completely to prevent personal injury. • The maximum weight for each drawer should be no more than 40 pounds. • The maximum product weight, including contents, should be no more than 600 pounds for Roll-Aways. • Close the cover and lock the drawers and doors before moving this product. The drawers or doors could come open and make the product unstable and tip, which may cause personal injury or product damage. • Remove the work surface, if provided, from the cart before mounting the chest. Failure to do so may cause the chest to slide off, which may cause personal injury or product damage. • When locking a chest, close the drawers before closing the cover for lock bars to work properly. • Spread the weight out evenly in the tote trays. If the weight is not spread evenly, the contents could shift and fall out, which may cause personal injury, and damage to the contents or tote tray. before first use F1294 2 Call 1-800-366-7278 for Service Parts Refer to Service Parts Drawing for full listing of Service Parts HARDWARE: • Attach each caster using (4) 14-10x5/8 hex screws per caster. _Li_' _;_,,.2_ _ 14--10 x 3/4 PHILLIPS SCREW • Wrench tighten all screws. • Return the cart to its upright position. !Y_%,_,_._.;,:_ _C_7/_ _;j_<4_ 14-10 x 5/8 HEX SCREW REMOVING AND INSTALLING DRAWERS: • Empty the drawer. SIDE HANDLE ATTACHMENT: • Fully extend the drawer. NOTE: Holes in the handle are tapped • Depress the release tab on both sides, requiring no nuts for installation. (this allows the slides to ride over the • Attach the side handle using (4) 14-10 x stops). Pull out to remove 3/4 phillips screws. Do not over tighten • To reinstall, carefully align the slides and screws. slowly push the drawer into the unit until the drawer stops. \ Release Left CASTER INSTALLATION: Right NOTE: Use adequate manpower for this operation. • To remove the slide from the unit, first • Lay the cart down on its back. Use remove the drawer (follow the procedure packaging material to protect the paint above). Lift and hold the spring retainer, finish. and push the slide upward. The slide • Mount both swivel casters on the same may now be removed. side of the cart. / / Spring Retainer 3 To reinstall the slide, place the slide in the appropriate position in the unit. Pull it toward the front of the unit until the spring retainer snaps into position and secures the slide. • For casters, use high quality bearing grease, (yearly). • Lubricate the slides, (twice yearly). • Lubricate lock with graphite, (yearly). • Periodically the drawer fronts, drawer trim, and other surfaces should be cleaned with a mild detergent and water. • Auto wax wilt preserve the storage unit's luster finish. Apply the wax as to a car. The wax wilt also help protect the unit against scratches. • Grease and oil can be removed with most standard cleaning fluids. For safety, use a nonflammable cleaning fluid. • If drawer liners are supplied, it is recommended they are used to protect the fin...