Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
• Always unplug the appliance from the mains supply before carrying out any filling, cleaning or maintenance operation on it. • NEVER IMMERSE THE APPLIANCE IN WATER OR ANY OTHER LIQUID. • Do not use this appliance close to baths, showers, wash basins or other containers of water. • This appliance must be cleaned after each use to prevent a build-up of grease and other waste. • When you have finished using the appliance, empty out any remaining water and rinse it thoroughly. • If the mains cable becomes damaged it will have to be replaced by the manufacturer or after sales service. • Repairs must only be carried out by an Authorised Technical Service Centre. • Avoid moving or repositioning the facial sauna while it is operating. • Switch the appliance on after filling the evaporation pan. • Do not use the appliance without the face mask and cover fitted. • The area around the evaporation pan becomes hot during use, so avoid touching this area while the appliance is operating. • Never immerse the appliance in water • The stains that appear inside the evaporation pan over time are due to the lime in the water. Clean the pan with diluted vinegar. OPERATING INSTRUCTIONS Before beginning, first clean your face thoroughly as usual. When your face is completely clean and dry, it is advisable to apply a little moisturizing cream to the skin. Preparation for use Do not plug the appliance in until it is ready for use. Make sure that the unit is completely dry before use. Place the appliance on a hard, flat, stable surface directly in front of you. Make sure that the mains cable does not hang freely and that it is out of children's reach. Take the diffuser cover and the mask off the base of the appliance. Fill the filling jug with tap water only. Fill up to the 20 ml mark. (Figure 1) Never fill beyond the maximum level mark shown on the inside of the evaporation pan. NOTE: If any liquid is spilled accidentally, unplug the unit from the mains electric supply. Place the diffuser cover and the mask back on to the appliance. Switching on Switch the appliance on using button 9, select the desired temperature: Position 1: Low heat setting (Gentle steam) Position 2: High heat setting (Intense steam) The pilot lamp “a” will light up. (Figure 2) The appliance will start to produce steam after a few seconds. To switch the appliance off, set the On/Off switch to the “0” position and unplug it from the mains supply. Use as a Facial Cleanser: Place the diffuser cover (4) and the skin- care treatment mask (2) on to the appliance. (Figure 3) The skin-care treatment mask is ergonomically shaped to fit the contours of the face. Close your eyes and rest your face on the edges of the mask. Relax for 5 minutes, letting your moisturising cream penetrate deeply. Afterwards, rinse and wash your face with fresh water or your usual cleansing astringent. Using the appliance for Inhalation: Place the diffuser cover (4) and the therapeutic and aromatherapy mask (3) on to the appliance. (Figure 4) The therapeutic and aromatherapy mask is ergonomically shaped to fit the contours of your nose and mouth. Add water soluble ethereal oils, the facial sauna is extremely suitable for inhalation purposes. For Aromatherapy treatment, first add water and then between 1 to 4 drops of essential oil. NOTE: Always add the essential oil after the water. IMPORTANT: Never add anything in the form of ointments or creams. When using soluble ethereal oils always read the manufacturer’s instructions, as certain oils may spit when heated. Never exceed the dose recommended by the supplier of the oil. After use, the pan will have to be cleaned of any remains. Just wipe the evaporation pan clean with a damp cloth. After consulting your doctor, you can use your appliance several times a day for therapeutic applications, especially for chest colds and chills. Timer function: Open the battery compartment located on the base of the appliance. (Figure 5) Fit the battery in to its compartment, observing the stated polarity (i.e. matching the “+” terminal on the battery with the “+” mark inside the compartment, and the “- “ terminal with the “-“ mark) . The timer does not switch the appliance off, it acts as a signal device to indicate and limit the time that you spend using the appliance. The timer allows you to select the duration of your facial sauna treatment. Chronometer function: Pressing button 12 will activate the chronometer function. The display will show the time that has elapsed. Pressing button 12 again will switch the chronometer off. Pressing it again will restart it. To set it back to “0” press the RESET button 11. Countdown function: Each time you press button 10 the displayed time will increase by 1 minute. This time setting can go from 1 to 59 minutes. To set it back to “0” press the RESET button 11. Once you have specified a time setting, press button 12 to commence the countdown. Pressing button 12 again will switch the chronometer off. Pressing it again will...