Assessments - 4, GPA: 3.8
(
)
)
|
Facilidade de uso
This will also happen if you type incorrectly or try to erase text. 3. On “Hyperterminal”, close the connection by clicking on the “hang up phone icon”. 4. Go into “File | Properties” and press “Configure”. 5. Use the ADVANCED /SERVICE / INFO dialog-box on the projector to make sure that the settings match those of the computer. Change the settings as described below. Confirm with OK two times to close the dialog boxes. “Bits per second” 38400 Baud “Data bits” 8 bit “Parity” None “Stop Bits” 1 bit “Flow control” None 6. Re-establish the connection to the projector, so that the status bar in the lower left corner reads “Connected”. 7. Open the transfer menu and select “Send File…” 8. Browse so that the correct BIN file, which can be found on the Proxima web page under“MLS resources Firmware.., can be selected and inserted in the file name field. It will be explained on the web page which BIN file (HW or SW) requires the different RS232 commands (RRP or FPG). Both the SW bin and the HW bin file are 805.xxx#.bin files. 9. Set protocol to Xmodem as described in figure below. Filename should read the name of the BIN file you have selected. PROXIMA ASA 7 FLASH UPGRADE USER GUIDE IMPRESSION A10+/A9+/A8+ 10. Press “Send”. The file will be transferred and the status and progress can be seen in the “Hyperterminal” status window. You will not receive visual feedback on the projected image during flash except the indicator stating time left and the progress of the EPROM flashing. 7. FINISHING THE FILE TRANSFER When the END prompt is visual in Hyperterminal the flashing is finished (approx. 2min.). 1. Leave the projector running for approximately 30 seconds to prevent that the reprogramming isn’t halted. The lamp of the projector will continue to work and the fans will continue running as in ON mode. At this time, the projector is reprogramming the EPROM. 8. VERIFYING THE DOWNLOAD After the download has been finished verification needs to be made that it has ended successfully and to stop the projector from running the power cord must be pulled out. 1. Reinstall the power cord and start the unit using normal procedures. 2. Disconnect all sources and verify whether the new SW was successfully installed or not by checking the ADVANCED /SERVICE / INFO dialog-box in the projector menu. If the new SW/HW number doesn’t appear as intended, please check the following : • Does the flashed file have the correct .BIN format? • Was the correct protocol used during the download? • Was the correct communication settings being used? 3. It is possible to reinsert the initial SW/HW by flashing with the original firmware revisionfor the projector. This is available through our web page under “MLS resources | Firmware..” . 4. If the unit does not start, the download has failed and the EPROM(s) must be replaced physically. PROXIMA ASA 8 ...
Este manual também é adequado para os modelos :Projetores - A10+ (42.67 kb)
Projetores - A8+ (42.67 kb)