Assessments - 2, GPA: 4.5
(
)
)
|
Facilidade de uso
Page 3 of 8 5. Set Date - Month Once the year is set, press the “ SET” button again and the Month digits will flash. Use the “ + ” and “ - / F°/ C°” buttons to select the correct month. 6. Set Date - Date Once the month is set, press the “ SET” button again and the Date digits will flash. Use the “ + ” and “ - / °F/ C°” buttons to select the correct date. To Change the Temperature Units To change the temperature reading between Fahrenheit or Celsius, press the “ - / °F/°C” button. To Set the Time Alarm 1. To turn the alarm on: Press the " ALM" button. The LCD will display the alarm icon . 2. To set the Alarm Time - Hour: Press and hold down the " ALM" button for 3 seconds until the hours digits flash. Use the “+ ” button to set the hour. Press the " ALM" button to confirm your setting and move to setting the minutes. 3. To set the Alarm Time - Minutes: The Minutes digits of the Alarm Time will flash. Use the “+ ” button to set the minutes. You can hold the " + " button in to speed up the setting of minutes by using five minute increments. Press the " ALM" button to confirm your minutes setting and to end the setting procedure. 4. To activate or deactivate the daily alarm: Briefly press the “ ALM” button once. When the alarm is active the clock displays the alarm icon in the upper right corner. When the alarm is deactivated, the alarm icon will not display. 5. About the Time Alarm: After 15 seconds without pressing any button, the clock switches automatically from alarm setting mode to normal clock mode. To Use The Alarm The alarm can be silenced by pressing any button. If it is not silenced, it will sound for 2 minutes before stopping on its own. The alarm repeats automatically after 24 hours. Page 4 of8 If the “ SNZ” button is pressed, the alarm will silence for approximately 5 minutes, after which it will begin to sound again. The alarm uses 3 different patterns of tone, beginning gently and increasing in intensity, known as a "Crescendo Alarm" . Battery Replacement Information To replace the battery: 1. Lift up the battery compartment cover and remove the battery. 2. Please take note to install the battery with the proper polarity as it relates to the battery diagram inside the battery compartment (+). The battery will fit tightly. To avoid start-up problems please ensure that the battery does not spring free. 3. Replace compartment cover. Help us to keep our environment clean. Please take any used batteries to an authorized depot for recycling. Immediately remove all low power batteries to avoid leakage and damage. Replace only with new batteries of the recommended type. When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or scouring agents as they may mark the LCD and casings. Do not submerge the unit in water. Furthermore, fix all parts in place where the units are adequately protected against moisture and rain. Special care shall be taken when handling a damaged LCD display. The liquid crystals can be har...
Este manual também é adequado para os modelos :Controle remoto - DIGITAL CLOCK WITH INDOOR TEMPERATURE WT-8002U (95 kb)
Controle remoto - Radio Controlled Projection Alarm WT-5110 (95 kb)
Controle remoto - Radio Controlled Projection Alarm WT-5350 (95 kb)
Controle remoto - TIMER WALL WT-8100 (95 kb)