Assessments - 5, GPA: 3.2
(
)
)
|
Facilidade de uso
Pass this manual on to whoever might acquire the device at a future date. Important safety instructions Proper use Children may only operate the remote control under adult supervision. The universal remote control can replace a maximum of ten remote controls. It can only be used for entertainment electronics with infrared receivers. The functions of the Universal remote control essentially correspond to those of the original remote control. The universal remote control is intended for private use. It is not suitable for commercial use. Any other use is considered improper use. The manufacturer declines to accept responsibility for damage(s) arising from improper use. There is a danger of injury in the event of improper handling of batteries! Batteries must be handled with special care. Take note of the following safety instructions: • Take the batteries out of the battery compartment as soon as they are depleted. • Do not throw batteries into a fire. Never subject batteries to high temperatures. • If you will not be using the device for a long period of time, remove the batteries to prevent them from discharging. • Explosion hazard! Non-rechargeable batteries must never be recharged. • Do not open the batteries or short-circuit them. • Battery acid leaking from a battery can cause inflammation of the skin. In event of contact with the skin, rinse with large amounts of water. If the liquid comes into contact with your eyes, rinse thoroughly with water, do not rub and immediately consult a doctor. • Always change all batteries at the same time and always use batteries of the same type. • Keep batteries well away from children. Children can put batteries into their mouths and swallow them. If a battery is swallowed medical assistance must be sought IMMEDIATELY. Laser The Universal remote control contains an infrared diode of laser class 1. A safety system prevents the emmision of dangerous laser radiation during use. To prevent eye injuries, do not modify or damage the safety system of the device. - 2 Damage to the device • If the device is defective, do not attempt to repair it yourself. In case of damage, contact the manufacturer or the manufacturer's service hotline (see Warranty information). • If liquid escapes from the device or if the device has been otherwise damaged, it must be inspected by the manufacturer or the manufacturer's service hotline. Contact the manufacturer or the manufacturer's service hotline (see Warranty information). Device summary q LCD display w /ALL OFF button e Device buttons r S button t Arrow buttons y EXIT button u CH +/— buttons i MACRO button o Number buttons a Button for one or two digit programme numbers s Teletext function buttons d AV button f Record/Playback buttons g Mute switching h VOL +/— buttons j MENU button k OK button l FAV / EPG button 1( Infrared sender/receiver 2) Battery compartment cover Tips: • The functions described here pertain to the theoretically ideal circumstance that the button structure of the respective original remote control is identical to this universal remote control. This only occurs, however, in rare cases. If, therefore, not all of the original remote control's functions can be reproduced it is not due to a dificiency in the Universal remote control. • All the brand names used in these instructions or in the accompanying code list are trademarks of the corresponding companies. - 3 Initial use Unpacking the device / checking the package contents Important! Keep the plastic packaging well away from small children. There is a risk of suffocation! • Unpack the device and accessories. • Check the package contents - Universal remote control (URC), - Operating instructions, - Manufacturers directory with device code list: - 2 x 1,5 V Batteries, type AAA/LR03 (Micro) • Remove the protective foil from the LCD display q. Note: Transport damage If you notice any transport damage contact the manufacturer or the manufacturer's Service-Hotline (see warranty information). Inserting the batteries Attention! The Universal remote control must only be operated with 1.5 Volt batteries (Type AAA, LR03). Carry out the battery change as quickly as possible. Preset settings will remain saved for approx. 1 minute. If new batteries have not been installed within this time all of the settings will have to be carried out again. The time of day will, however, in any case be deleted. 1. Open the battery compartment cover 2) in the direction of the arrow. 2. Insert the batteries as shown in the diagram and close the battery compartment. The LCD display q is activated as long as batteries are installed. The following diagram shows the LCD display q after the batteries have been installed or changed. - 4 Note: If no LCD display q is visible check the polarity of the batteries or install new ones. Operating components LCD display The LCD display q is divided into fields. Text field 2! Here is shown the currently selected device, for example DVD, TV VCR etc. Infrared symbo...