Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
Philips' patented Handsfree autosearch tests all the codes one after another and finds the right one for you! The search time averages about 90 seconds. (Maximum search time is 5 minutes for TV; 2 minutes for VCR and 4 minutes for SAT.) Make sure the TV, VCR etc. is switched on. If it's a VCR, insert a tape and start playback. You will know when the correct code has been found because the equipment will switch off or the VCR will stop playback. 1 Press and hold and 1 3 at the same time until the green LED lights up. 2 Press to start the search. Each time the green LED blinks, another code is sent. When the right code is found, the equipment switches off (the VCR will stop playing). 3 English 3 Immediately press to stop the search. If you missed the correct code because the search went too far, switch the equipment back on, then press P (down) to send the previous code again. Press (down) repeatedly until the equipment switches off again. P 4 Once you've found the correct code, press to lock it in memory. The green LED blinks twice. That's it! Now, switch the equipment manually on again, then press a few keys on the remote to check that the equipment responds correctly. In the rare instance that it doesn't, try again from step 1 to find a better code. Note that code! To save time if you ever need to setup again, make a note of the correct code inside the battery case and in the back of this booklet. In case you have forgotten to note the code you can still 'read out' the code from the remote. Here's how: 1 Make sure you've selected the right mode (with 1 6 ). Then press and release and at the same time; the green LED lights up. 2 Press 1 . The green LED goes out. 3 Press and count the number of times the green LED blinks. This is the first digit of the 3-digit code. (No blinks means the digit is zero.) Press 3 2 and count the number of blinks for the second digit. Press and count the number of blinks for the third digit. ADVANCED TIPS AND TRICKS TO CHANGE SAT MODE TO CONTROL A SECOND TV The SAT mode on this remote is used to control additional equipment. It is factory preset to control a satellite receiver, but you can change it to control a second TV, for example. Before you start, press to select SAT, and make sure the second TV is switched on. 1 Press and hold 1 and 6 at the same time -for about 3 seconds- until the green LED lights up. 2 On the keypad, enter 992. 3 Press to select TV mode, then press any key except once more. That's it! Don't forget you now need to setup the remote to operate this second TV - see Getting started. TO CONTROL THE SECOND TV'S VOLUME If you have installed a second TV under SAT mode, you can also control that TV's volume when you are in VCR mode. Before you start, press to select VCR. 1 Press and hold 1 and 6 at the same time until the green LED lights up (about 3 seconds). 4 English 2 On the keypad, enter 993. 3 Press to select SAT. 4 Press any key (except ). That's it! Now, when you're in VCR mode, (up/down) cont...
Este manual também é adequado para os modelos :Controle remoto - SBCRU430/00 (597.9 kb)
Controle remoto - SBCRU430/02 (597.9 kb)
Controle remoto - SBCRU430/85 (597.9 kb)