Assessments - 5, GPA: 3.8
(
)
)
|
Facilidade de uso
For warranty service on Linear equipment return product, at sender’s expense to: Linear Hong Kong 19/F Hounor Industrial Centre, 6 Sun Yip StreetChai Wan, Hong Kong Attention: Repairs Department REPAIRS POLICY Charges will be made for equipment that is not in warranty, shows customer abuse, or is damaged by the effects of lightning, water, fire, or other abnormal happenings. Customer’s equipment sent in for repair may be repaired or replaced with new or remanufactured equipment at Linear’s discretion. The customer is always responsible for shipping and handling charges to the repairs facility. Linear will pay return shipping and handling charges on “in warranty” products shipped back to the customer. The customer will be billed for the return shipping and handling charges on “out of warranty” products. There will be a 50% expedite fee for any express requests. The International Sales Manager must be notified prior to the return of product to Linear. All international returns must have an International Repair Authorization number (IRA#). The number must be marked on all packages. Failure to do so will cause delays in processing. IMPORTANT !!! Linear radio controls provide a reliable communications link and fill an important need in portable wireless signaling. However, there are some limitations which must be observed. The radios are required to comply with local rules and regulations as radio devices. As such, they have limited transmitter power and therefore limited range. A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies, regardless of code settings. Changes or modifications to the device may void regulatory compliance. Infrequently used radio links should be tested regularly to protect against undetected interference or fault. A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users. Copyright © 2003 Linear Corporation 220101 A EMERGENCY PRESS ONCE TO ARM CONSOLE TO AWAY MODE PRESS AGAIN TO DISARM CONSOLE TO OFF MODE ONE CHIRP FOR ARM TWO CHIRPS FOR DISARM ONE BUTTON REMOTE TWO BUTTON REMOTE PRESS FOR HOME AUTOMATION ON PRESS AGAIN FOR H/A OFF ONE BING FOR H/A ON ONE BING FOR H/A OFF NOTE: PRESSING BOTH BUTTONS FOR 5 SECONDS ON THE TWO BUTTON REMOTE WILL SOUND THE EMERGENCY SIREN REMOVE TWO CASE SCREWS HOLD CASE TOGETHER AND FLIP OVER CAREFULLY LIFT TOP OF CASE OFF REPLACE THE REMOTE CONTROL BATTERIES WHEN THE UNIT ONLY WORKS CLOSE TO THE CONSOLE OR IF IT STOPS WORKING ALTOGETHER CAREFULLY REMOVE THE CIRCUIT BOARD NOTE BATTERY LOCATIONS BOARD ALIGNMENT POSTS WARNING: HOLD BOARD BY EDGES ONLY PLACE FRESH BATTERIES ON SPRING IN HOLDER PLUS (+) SIDE UP MINUS (-) SIDE UP WARNING: DO NOT INSTALL BATTERIES BACKWARDS, UNIT WILL BE DAMAGED! BE SURE BATTERY SPRING IS IN PLACE BATTERY TYPE CR1616, CR1620 OR DL1620 PLACE BOARD ON...
Este manual também é adequado para os modelos :Controle remoto - DF-41/EC (124.2 kb)
Controle remoto - DF-41/EC (124.2 kb)