Assessments - 12, GPA: 4.3
(
)
)
|
Facilidade de uso
When using the vacuum cleaner on stairs, always ensure that you hold the appliance steady with one hand. • Do not leave the appliance unattended whilst it is switched on and ensure that children do not play around with the appliance. • Always pull out the plug - if the appliance malfunctions during operation - before cleaning and maintenance - after use - when changing the filter. • Never unplug the appliance by pulling at the cable, but only by removing the plug directly from the socket. • Ensure that the main cable is not exposed to either heat or chemical substances, nor that it is pulled across sharp edges or surfaces. • Avoid using extension cables in wet rooms. • Never repair damage to the appliance, to the 1.2 Safety points 11 accessories or to the cable (special cable required); have repairs done only by an authorised customer service station, because modifications to the appliance can pose a risk to your health. Ensure that only original spare parts and accessories are used. Do not expose the appliance to the elements, humidity or heating sources. Never aim the cleaning jet at people or animals, at electrical sockets or electrical appliances. After wet vacuuming, empty the collecting bin immediately. Chemicals such as the cleaning fluid concentrates should not be handled by children. The functionality and complete effectiveness of the appliance can only be warranted if you use original THOMAS cleaning fluids. Persons with sensitive skins should avoid direct contact with the cleaning fluid. If cleaning fluid comes into contact with mucous membranes (eyes, mouth, etc.), immediately flush with water. We care about the environment Do not simply throw out packing materials and old appliances! Packing materials: Take the packing carton to paper recycling collection points. Take the polyethylene (PE) plastic bag to collection points to be reused. What to do with the appliance after the end of its useful life: Dispose of the appliance according to local regulations and pull out and cut off the mains cable beforehand. Assembly of castor wheels f A) Undo the snap-on fasteners and lift the motor block. Push the castor wheels and the pegs into the base of the collecting bin until they snap into place. Dry vacuuming THOMAS BRAVO 20 A After wet vacuuming, the appliance must be absolutely dry; dry off the flexible hose or tubes if necessary beforehand. Never dry vacuum without filters or with damaged filters. ® Remove the cleaning fluid tank. © Assemble the foam rubber filter, tissue filter and clamping ring and fasten them with the turning clips. Press the filter sack on the suction connection firmly and lay it against the wall of the collecting bin. ® Clip the hose for the cleaning fluid to the underside of the motor block. (H) Place the motor block on top and secure it by means of snap-on fasteners. Connecting the flexible hose. Remove the hose by turning the hose connecting piece and withdrawing the hose. Assemble the accessories you require. Connect the mains cable. ® Turn the appliance on with the On/Off switch. The pump switch (7) must not light up. Suction control (11, figure P) allows you to vary the suction power. - Sliding air trap closed = full suction power - Sliding air trap open = reduced suction power THOMAS BRAVO 20S Aquafilter A Never use your AQUAFILTER appliance in dry vacuum mode without the Aquafilter, the fine particle textile filter and an appropriate water level. Do not vacuum up large quantities of particle dust, e.g. flour, cocoa powder, cement, etc. 12 ® Remove the cleaning fluid tank. ® Connect up the two-piece AQUA filter, pushing it together until the two parts fit snugly, and push it firmly onto the suction socket. Note the marker guides! The AQUA filter has to snap into place on the floor of the suction canister and has to lie there evenly. Fill 2 litres of clear water into the collecting bin. Hang the fine particle filter in the collecting bin by turning down the top edge. ® Clip the suction hose for cleaning fluid to the underside of the motor block. Fit tissue filter (29) by means of the clamping ring (32) and fasten with turning clips. Place the motor block onto the collecting bin and snap shut with snap-on fasteners. Connect flexible hose. Remove the hose by turning the hose connecting piece to the side and withdrawing the hose. Assemble the desired accessories. Connect the mains cable. ® Switch on the appliance with the On/Off (6) switch. The pump switch (7) must not light up. Suction control (11, figure P) allows you to vary the suction power. - Sliding air trap closed = full suction power - Sliding air trap open = reduced suction power Cleaning and care of the AQUA filter system A For reasons of hygiene, empty, clean and dry the AQUAFILTER system and the collecting bin after each use. Dirty water and damp parts will promote the growth of bacteria and mildew. Clean the fine particle filter - according to...
Este manual também é adequado para os modelos :Aspiradores - Bravo 20S Aquafilter (500.45 kb)