This system, utilizes an approved 3-conductor power cord and 3-prong grounding type attachment plug, which should be used with the proper grounding type receptacle, in accordance with the National Electric Code, Canadian Electrical Code, and Underwriters’ Laboratories specifications. If your unit requires less than 150 volts It has a plug that looks like Fig, “A”. It will fit directly into the proper type of 3-wire grounding receptacle. The unit is then grounded automatically each time it is pl

Service Information Black & Decker offers a full network of company-owned and authorized service locations throughout North America. All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you. To find your local service location, refer to the yellow page directory under “Tools— Electric” or

4. If the power pack does not charge properly – (1) Check current at receptacle by plugging in a lamp or other appliance. (2) Check to see if the receptacle is connected to a light switch which turns power off whenyou turn out the lights. (3) Move charger and power pack to a surrounding air temperature of +40°F (4.5°C) to +105°F (40° C). (4) If the receptacle and temperature are OK, and you do not get proper charging, take or send the power pack and charger to your local Black & Decker service c

c. If the battery liquid gets in your eyes, flush them with clean water for a minimum of 10 minutes and seek immediate medical attention. MEDICAL NOTE: The liquid is a 25-35% solution of potassium hydroxide. IMPORTANT CHARGING SAFETY INSTRUCTIONS CHARGING PROCEDURE THE BATTERY PACK IS NOT FULLY CHARGED AT THE FACTORY. CHARGE BATTERY PACK FOR AT LEAST 9 HOURS BEFORE USE. The charger is designed to use standard household 120 volt 60 Hz power. 1. Plug the charger into any standard 120 Volt 60 Hz el

Vacuum Indicator Lights for Bare or Carpet Floor Use (see Figure 7A and 7B) There are two indicator lights on the left side of the power head. 1. Pressing down either the foot pedal or thumb switch once will turn ON the forward light, indicating suction only. Use this setting when vacuuming bare floors or using accessories. 2. Pressing down either the foot pedal or thumb switch a second time will turn ON both lights, indicating the brush roll is now rotating. Use this setting when vacuuming carp

• Do not vacuum burning or smoking materials, such as lit cigarette butts, matches or hot ashes. • Do not use on or near hot surfaces. Keep cord away from heated surfaces. • Do not use without dirt bowl and filters in place. • Turn off the switch before unplugging. • Use only extension cords UL-rated or cUL at 15 amperes. Extension cords rated for less amperage may overheat. Care should be taken to arrange the cord so that the cord cannot be pulled or tripped over. • Using improper voltage may r

H • Figure I - Empty the dust from the bowl. • For a more thorough cleaning, remove bowl as described below. For a more thorough cleaning (figures J, K, L & M) • Figure J - Remove the dust bowl by pressing the bowl release button and pulling the bowl straight off. • Remove filters from within the bowl. IJ • Figure K - Models CHV1410, CHV1410B, CHV1510, CHV1610 have a plastic pre-filter and an inner cloth filter. To separate the cloth filter from the plastic filter, twist the plastic filter in a

Wash hands after handling. WARNING: To reduce the risk of fire, electrical shock or injury: • The intended use is described in this manual. The use of any accessory or attachment or the performance of any operation with this appliance other than those recommended in this instruction manual may present a risk of personal injury. • Close supervision is necessary when any appliance is used by or near children. Do not allow to be used as a toy. • Keep children and animals at a safe distance when usi

No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added to the appliance. Servicing a double-insulated appliance requires extreme care and knowledge of the system and should be done only by qualified service personnel. Replacement parts for a double-insulated appliance must be identical to the parts they replace. If mailing or shipping your vacuum, pack it carefully in a sturdy carton with enough packing material to prevent damage. Include a note

1. Pressing down either the foot pedal or thumb switch once will turn ON the forward light, indicating suction only. Use this setting when vacuuming bare floors or using accessories. 2. Pressing down either the foot pedal or thumb switch a second time will turn ON both lights, indicating the brush roll is now rotating. Use this setting when vacuuming carpeted surfaces. 3. Pressing down either the foot pedal or thumb switch a third time will turn the vacuum OFF. Detaching the Upright Handle (see