Log:
Assessments - 2, GPA: 4 ( )

Instruções de Operação Eton, Modelo SOLARLINKFR360 FR360

Fabricante : Eton
Arquivo Tamanho: 653.29 kb
Arquivo Nome : Eton_FR360manual_SW_081409.pdf
Língua de Ensino: itenesfrde
Ir para baixar



Facilidade de uso


• How long does it take to fully charge the radio’s battery with the solar panel? About 8-10 hrs in direct sunlight. • How long will the radio play when fully charged? About 5 hrs at low volume. CHARGING CELL PHONES Press the button labeled CELL. Plug the USB cell phone charging cord into the USB PHONE CHARGER jack, the second socket from the left at the rear of the radio. Plug the other end of the cord into the cell phone charging tip and then into the jack of the cell phone. About 3 minutes of cranking results in one short emergency call. To purchase a charging tip and cord for your cell phone, go to and purchase USB cord part# PS00271-0001. NOTE: When charging a cell phone via the USB cell phone charger, it is important to turn the crank at least 2 revolutions per second, or until you see the green or orange LED above the crank handle turn on. This is an indication that the phone is receiving enough power from the radio. Continue to crank at this rate until you are satisfied that an appropriate level of charge has been received by your cell phone. If you decide to stop cranking for whatever reason, please wait at least 5 seconds before beginning to crank again. Not following these instructions may cause damage to your cell phone for which Eton Corporation disclaims any liability and will not be held liable for any actual or consequential damages related to this matter. SOLARLINK FR360SW OWNER’S MANUAL THE LIGHT ABOVE THE CRANK A red light means radio is on. A green light means that there is sufficient crank speed to enable a charge. LCD BACKLIGHT Press the DISP button to turn on the backlight for the LCD and the buttons above the LCD. It automatically shuts off after about 5 seconds. SELECTING BANDS AND TUNING IN STATIONS The US version plays AM (520-1710 KHz), FM (87.5-108 MHz) and Shortwave (5.8-21.8 MHz). The European version plays AM (531-1611 KHz), FM (87.5108 MHz) and Shortwave (5.8-21.8 MHz). Turn the radio on. Select AM, FM or SW1/SW2 with the knob above the TUNE button (right side of the radio). When listening to FM pull up the telescopic antenna all the way. When tuning AM stations the telescopic antenna is not needed and can be lowered. Tune in stations by revolving the TUNE knob (right side of the radio). Alternatively, you can use the automatic scan: Start the scan using DOWN – or – UP key. The scanning stops automatically when receiving worthy channel. SHORTWAVE LISTENING Shortwave enables listening to broadcasts over vast distances including other countries and continents. The following information will help you get the best results. • During the day, frequencies above 13 MHz are usually best. • At night, frequencies below 13 MHz are usually best. • Around sunset and sunrise, the entire shortwave range may be good. Getting very close to a window and holding the radio improves shortwave reception. To learn about shortwave we recommend the two publications below, published yearly and available from major SOLARLINK FR360SW OWNER’S MANUAL booksellers. Additionally, the Internet is a great resource for learning about shortwave. PASSPORT TO WORLD BAND RADIO Published by International Broadcasting Services (IBS); IBS North America, Box 300, Penn’s Park PA 18943. Phone: (215) 598-9018. WORLD RADIO TV HANDBOOK Published in the USA by Watson-Guptill Publications, 770 Broadway, 7th Floor, New York, NY 10003-9595. SETTING THE TIME AND ALARM The clock is a 12/24-hour clock, as a 12-hour clock showing PM in the display starting at Noon. To change from 12 to 24 hour time or vice versa: 1. With the radio turned off, do three short presses of the SET button. 2. 12 or 24 appears in the display. 3. Press the MIN/UP or HOUR/DOWN buttons to change it. 4. Press SET to finalize it. To set the time: 1. With the radio turned off, do a short press on the SET button. 2. While the hour flashes press the HR/UP or MIN/DOWN button to set the hour. 3. Press SET again. 4. While the minute flashes press the HR/UP or MIN/DOWN button to set the minutes. 5. Press SET to finalize To set the alarm: 1. With the radio turned off, press the ALARM button and then the SET button. 2. ALARM appears on the left of the LCD and the hour flashes. 3. Press HR/UP or MIN/DOWN button to set the alarm hour. 4. Press SET again. SOLARLINK FR360SW OWNER’S MANUAL 5. While the minute flashes press the HR/UP or MIN/DOWN button to set the alarm minutes. 6. Press SET to finalize. TURNING THE ALARM ON AND OFF With the radio on or off press the ALARM ON/OFF button. Notice that when it’s on, ALARM appears in left of the LCD. SLEEP FEATURE The sleep timer can be activated with the radio turned on or off. Activating the sleep timer enables the radio to play for 90, 60, 30 and 10 minutes, then shut off automatically. To activate it press the SLEEP button (in the upper right, above the display) until the minutes you want it to play appear, then stop pressing. SLEEP appears to the left in the display and th...


Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias