Assessments - 3, GPA: 3.7
(
)
)
|
Fotos e especificações Sony ICF-C205 |
Facilidade de uso
The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Specifications Time display: 12-hour system Frequency range: FM: 87.5 - 108 MHz AM: 530 - 1 605 kHz Speaker: Approx. 5.7 cm (2 1.4 inches) dia., 8 . Power output: 150 mW (at 10 % harmonic distortion) Power requirements: 230 V AC, 50 Hz For the power back-up function: 9 V DC, one 6F22 battery Battery life: Approx. 80 hours, using Sony 006P (6F22) battery Dimensions: Approx. 143 . 54.5 . 117.5 mm (w/h/d) (5 3.4 . 2 1.4 . 4 3.4 inches) incl. projecting parts and controls Mass: UK: Approx. 437 g (15.4 oz.) not incl. battery Australia: Approx. 396g (14.0 oz) not incl. battery Design and specifications are subject to change without notice. Lead-free solder is used for soldering. Halogenated flame retardants are not used in printed wiring boards. Installing the battery To keep good time, your Dream Machine needs one 6F22 battery (not supplied), in addition to house current. The battery keeps the clock operating in the event of a power interruption. Before setting the time on your Dream Machine, install the battery with correct polarity. Installing the battery (see Fig. A-1) Clip the battery in place observing correct polarity, and insert it in the battery compartment until it clicks into position. Removing the battery (see Fig. A-2) Turn the unit upside down and push the battery forward from the battery compartment. • After a power interruption, the displayed time may not always be correct (it may gain or lose about 10 minutes per hour). Knowing when to replace the battery To check battery power, unplug the AC power cord from the wall outlet and plug it in again after a few minutes. If the displayed time is incorrect, replace the battery with a new one. Battery warning When the unit will be left unplugged for a long time, remove the battery to avoid undue battery discharge and damage to the unit from battery leakage. Setting the Clock 1 Plug in the unit. The display will flash “AM 12:00”. 2 To set the hour, while holding down CLOCK, press TIME SET H. When the correct hour appears in the display, release CLOCK. 3 To set the minute, while holding down CLOCK, press TIME SET M. When the correct minute appears in the display, release CLOCK. The clock will begin to operate when you release TIME SET M. • Each press on TIME SET H or TIME SET M advances the displayed number by one. • The minute digits advance to “00” after “59”. The hour digits do not advance by pressing TIME SET M. • To adjust the time exactly to the second, set the time one minute behind the time you want to set. Press TIME SET M simultaneously with the time signal. Operating the Radio 1 Set the function selector to RADIO ON to turn on the radio and adjust VOLUME. 2 Select BAND and tune in to a station using TUNING. • To turn off the radio, set the function selector to OFF. Improving the reception FM: Extend the FM wire aerial fully to improve reception. AM: Rotate the unit horizontally for optimum reception. A ferrite bar aerial is built into the unit. Do not operate the unit over a steel desk or metal surface, as this may lead to interference of reception. Setting the Alarm To set the radio alarm, first tune in to a station and adjust the volume. 1 To set the hour for alarm, while holding down ALARM, press TIME SET H. When the desired hour appears in the display, release ALARM. 2 To set the minute for alarm, while holding down ALARM, press TIME SET M. When the desired minute appears in the display, release ALARM. 3 Set the function selector to ALARM MODE • RADIO or ALARM MODE • BUZZER. The alarm will come on at the preset time and automatically turn itself off after 119 minutes. • To shut off the alarm, set the function selector to OFF. To sound the alarm at the preset time the next day, set the function selector to ALARM MODE • RADIO or ALARM MODE • BUZZER again. • To deactivate the alarm, set the function selector to OFF. • To doze a few more minutes, press SNOOZE/ SLEEP OFF. The alarm will shut off but will come on again after about 9 minutes. You can use this function as many times as you like. • To adjust the radio alarm volume, turn VOLUME. The buzzer volume is fixed. • To check the preset time, press ALARM. Setting the Sleep Timer Enjoy falling asleep to the radio using the built-in sleep timer that shuts off the radio automatically. 1 While listening to the radio, set the function selector to OFF. 2 Press SLEEP. The radio turns on. It will go off after 59 minutes. • To turn off the radio before the preset time, press SNOOZE/SLEEP OFF. • Every time you press SLEEP, the sleep timer is reset to 59 minutes. • When you set the function selector to ALARM MODE • RADIO or ALARM MODE • BUZZER, if the preset alarm time comes while the sleep timer is operating, the radio or buzzer sounds depending on which...