Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
5 LOCATION OF CONTROLS LOCATION OF CONTROLS 1 2 7 8 9 3 13 12 11 10 16 14 15 4 5 6 FRONT 1. Star Light 2. Tuning Control 3. ALARM SET Button 4. TIME SET Button 5. Sleep Button 6. VOLUME Control 7. Display 8. AC Cord (Rear of Unit) 9. Battery Compartment (Bottom of Unit) 10. Function (OFF/ON/BUZZ/ AUTO) Switch 11. Band (AM/FM) Switch 12. HOUR Button 13. MIN Button 14. Star Light Button 15. Snooze Button 16. FM Antenna Wire (Rear of Unit) DISPLAY A B C D E AM PM A. Sleep B. Snooze C. Radio Alarm D. Time G. Clock Setting H. Radio I. AM/PM E. Buzzer Alarm F G H I F. AM/FM AM FM 6 INSTALLATION Unravel the AC cord and connect it to a conveniently located AC outlet having 120V and 60Hz only. The Clock Display will illuminate and “12:00” will blink in the display and the backlight will light. NOTE: If the AC plug does not fit into a nonpolarized outlet, do not file or cut the wide blade. It is the user’s responsibility to have an electrician replace the obsolete outlet. If the AC cord is disconnected or if there is a power failure, this electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with two (2) AAA size batteries (not included). To install the batteries: • Remove the battery compartment door by inserting a small screwdriver, paper clip or similar item into the tab while gently pushing to remove. • Insert two (2) AAA size batteries into the battery compartment. Be sure to observe the polarity markings AC Plug AC Outlet +.+. INSTALLATION Unravel the AC cord and connect it to a conveniently located AC outlet having 120V and 60Hz only. The Clock Display will illuminate and “12:00” will blink in the display and the backlight will light. NOTE: If the AC plug does not fit into a nonpolarized outlet, do not file or cut the wide blade. It is the user’s responsibility to have an electrician replace the obsolete outlet. If the AC cord is disconnected or if there is a power failure, this electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with two (2) AAA size batteries (not included). To install the batteries: • Remove the battery compartment door by inserting a small screwdriver, paper clip or similar item into the tab while gently pushing to remove. • Insert two (2) AAA size batteries into the battery compartment. Be sure to observe the polarity markings AC Plug AC Outlet +.+. which are engraved inside the battery compartment. If the batteries are inserted incorrectly, the unit will not operate. • Replace the battery compartment door. Be sure to check the condition of the batteries periodically by disconnecting the AC cord and connecting it again two or three minutes later. The preset times should continue operating. If the present time does not appear, it indicates the batteries are dead or not connected properly. BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the batteries as indicated next to the battery compartment. Reversed batteries may cause damage to the device. 3. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc) or old batteries with fresh ones. 4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. 5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.) 7 OPERATION Adjust the volume using the Volume control 1. Slide the Function switch 2 to the OFF position to turn the unit off. 21 3 Slide the Function switch 1 to the ON position to turn the unit on; the AM or FM indicator will light. Slide the Band switch 2 to select AM or FM. 2 1 1 Tune a station by rotating the Tuning control until the desired frequency is shown at the top of the dial. 2 TO LISTEN TO THE RADIO Antennas FM: Extend the FM antenna wire for best reception. AM: Turn the unit for better AM reception. Backlight: The display’s backlight will always be on when the unit is plugged in. OPERATION Adjust the volume using the Volume control 1. Slide the Function switch 2 to the OFF position to turn the unit off. 21 3 Slide the Function switch 1 to the ON position to turn the unit on; the AM or FM indicator will light. Slide the Band switch 2 to select AM or FM. 2 1 1 Tune a station by rotating the Tuning control until the desired frequency is shown at the top of the dial. 2 TO LISTEN TO THE RADIO Antennas FM: Extend the FM antenna wire for best reception. AM: Turn the unit for better AM reception. Backlight: The display’s backlight will always be on when the unit is plugged in. TURNING THE STAR LIGHT ON/OFF 1 To turn the star light on, press the Star Light button; the star light will then light from dim to bright repeatedly on the castle top. To turn the Star light off, press the ...
Este manual também é adequado para os modelos :Receptores de rádio - DCR4500-P (1.08 mb)