Assessments - 4, GPA: 4.8
(
)
)
|
Facilidade de uso
2. Press the Clock Adj. Button again. The minute display will flash. Press the or Button until the current minute is displayed. Hold for rapid advance. 3. Press the Alarm Set Button during time setting to toggle 12-hour or 24-hour display format. 4. Press the Clock Adj. Button again to confirm the clock setting. You will hear 2 beeps indicating the clock time is set. 5. Press the DST on/off Button located on the back of the unit to add one hour for daylight saving time (on) or to subtract one hour for standard time (off). The icon will appear on the display to indicate DST is on. Setting the Time 4 Using iP16 Install AC Adaptor Connect the AC adaptor cable plug into the jack on the back of the iP16, then plug the AC adaptor into the wall outlet. Install iPhone/iPod Insert Your iP16 comes with a double-sided insert to ensure certain iPhone/iPod models fit properly in the dock. To place an insert: 1. Identify the side of the insert that matches your iPhone/iPod model (see table on page 1). 2. Gently press the iPod insert into the dock with the proper side facing the connector pins. Install iPhone/iPod Insert Charging Your iPhone/iPod 1. Dock an already playing iPhone/iPod and the iP16 will automatically turn on. You will hear the music playing from your iPhone/iPod. Note: If the volume on the playing audio is too low on the iPhone/iPod, the iP16 may not detect that the iPhone/iPod is in play mode. Press the button once to play iPhone/iPod. 2. When the iPhone/iPod is docked and in standby mode, press the button on the iP16 to play your iPhone/iPod. 3. Press play/pause on your iPhone/iPod to pause play; press again to resume it. 4. Press the or buttons on the iP16 to adjust the system volume. 5. To turn off the unit, press the button on the iP16. Your iPhone/iPod will continue charging while in the dock. Listening to Your iPhone/iPod Installing/Replacing Batteries for Portable Operation The iP16 uses 4 “AA” batteries for portable operation. The iP16 will not charge your iPhone/iPod while operating on batteries. If sound becomes weak or distorted, it is time to replace the batteries. • Open the battery compartment cover located on the bottom of the unit. • Insert 4 “AA” batteries as indicated. Replace battery compartment cover. • We recommend the use of alkaline batteries for longer life. NOTE: To save battery life, when running on batteries, unit will automatically power OFF after 3 minutes of non-use (no song playing). Batteries information: • Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries. Note: Please make sure you are using the correct side of the insert for your iPhone/iPod model, if needed (see Install iPhone/iPod Insert) and that your iPhone/iPod is properly docked into the iP16. 1. While your iPhone/iPod is docked in the unit and the unit is connected to AC power, it recharges until fully charged. iPhone/iPod will not be overcharged. Unit will not charge iPhone/iPod when operating on batteries. Alaarmm OOpeerrationn SSlleeeepp OOppeerraattiioonn The iP16 Audio System for iPhone/iPod features “Sure Alarm”. Provided you have installed the 4 “AA” batteries, if a power failure occurs or the AC adaptor is accidentally disconnected, the alarm will still wake you up. This unit also features Gentle Waking, which gradually increases the volume of whatever alarm you set. NOTE: TO WAKE TO iPhone/iPod, YOUR iPhone/iPod MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY MODE) OR NO iPhone/iPod ALARM WILL SOUND. Setting the Alarm 1. Press and hold the button until the hour display flashes. Press the or Button until the desired alarm hour is displayed. Remember to set the correct AM or PM time, indicated by PM on the display; there is no AM indicator. 2. Press the button again, then press the or Button until the desired alarm minute is displayed. 3. Press the button again to exit the setting mode. You should hear 2 beeps indicating the alarm is set. Note: Once you set the alarm time, the alarm will be automatically armed, indicated by the icon. To disarm the alarm, press the button . The icon will disappear and the alarm will not sound at the set time. Note: Make sure to adjust volume level for a comfortable wake up volume. 4. When the alarm is sounding, the icon will flash. • To snooze during the alarm, press the Snooze/Dimmer Button. The alarm will be silenced for 9 minutes, then come on again. • To turn the alarm off and reset it to come on the next day, press the Button. 5. If the alarm is not turned off once it sounds, it will play for one hour then turn off automatically. This cycle will repeat every 24 hours unless the controls are changed. Note: Please make sure your iPhone/iPod has enough songs to play for one hour, otherwise please set the iPhone/iPod repeat mode to ON. Note: If there is no iPhone/iPod present or there is no music detected on the iPhone/iPod at alarm time, the iP16 will automatically switch to buzzer alarm. 1. When the iP16 is off or while listening to your...