Assessments - 1, GPA: 4
(
)
)
|
Facilidade de uso
@ @ @ @ A station has been preset but it cannot be received by pressing the P.CALL key. . The frequency of the preset station is not tunable. . The preset memory has been cleared because the power cord has been unplugged for a long period or operated to reset. . Preset stations with tunable frequencies. . Preset stations again. ) ) Standby condition is reached by power ON. . The speaker cord connection is not correct or the operation of the microcomputer temporarily has become abnormal. . Reset the microcomputer. . Check the speaker connection. If this does not help, contact your dealer for service. T ! Standby condition is reached suddenly . The temperature protection inside the unit . Leave the unit for about 15 minutes in while listening to music. has operated because of an excessive volume. standby condition to cool down, and then perform power ON. During standby, the standby indicator will flash faster than normal, but when it goes out, the unit has returned to normal condition. If normal return is not obtained even when this operation has been repeated, contact your dealer for service. No sound from the surround speakers . The LISTEN mode is STEREO. . Select Surround with the LSTN M. key.t Knowledge DVR-5070 (EN) DVR-5070 (EN) Knowledge Symptom Cause Remedy Remote control operation is not possible. . Batteries are exhausted. . The remote control is too far away from the system, the controlling angle is deviated or there is an obstacle in between. . There is no disc set in the component to be played. . Replace with new batteries. . Operate the unit inside the remote controllable range. . Set a disc in the component to be played. ^ ^ . . ..... Operation has been performed with the keys of the main unit. . ..... A nonfunctional key has been pressed . ..... Perform operation after once pressing the key for the input or device to be operated. & DVD / CD player unit Symptom Cause Remedy Playback does not start when the play (6) key is pressed. .There is no disc in the player. .There are no signals recorded on the side of the disc being played. .Load a disc and press the play (6) key. .Turn the disc over and properly place it on the disc tray. . . Playback starts but no image/sound is seen/heard. .The TV is not turned on. .The connection cords are not properly connected. .Turn on the TV. .Properly reconnect the connection cords. The picture is disrupted when the image is fast forwarded or fast reversed. .The picture is slightly disrupted during fast forward and fast reverse operations. .This is not a malfunction. No sound is heard. .The volume control of this set is not adjusted properly. .The player is in a special playback mode. .Set the sound volume to an appropriate level. .Press the play (6) key to resume normal playback mode. & . The picture does not look good or the picture/sound quality is poor. .A nearby device is generating noise. .The disc is dirty. .The disc is damaged. .There is condensation on the optical lens. .Separate this unit as far as possible from the device you think is generating the noise. .Refer to the “Disc handling precautions” section and wipe dirt from the disc. .Use a new disc. .Refer to the “Caution on condensation” section and evaporate the condensation. 8 7 It takes a while for the disc to start playing. .Time is required for the unit to detect the disc type and size and for the rotation of the motor to stabilize. This is not a malfunction. .Approximately 10 to 20 seconds are required for a disc to start playing, although the time differs depending on the disc. The top and bottom of the screen cannot be seen. .Playback is made with a setting different from the TV aspect ratio. .Match the aspect ratio. e° A VCD cannot be played using menus. .The VCD disc being played is not compatible with P.B.C. .Menu playback is available only with VCD discs recorded with P.B.C. The subtitle is not displayed. .The DVD disc being played does not contain the recording of subtitles. .The subtitle mode is set to off. .The subtitle cannot be displayed when the DVD disc being played does not contain the recording of subtitles. .Press the S.TITLE key to switch on the subtitle mode. ° . The voice (or subtitle) language cannot be changed. .The DVD disc being played does not contain the recording of more than one audio (or subtitle) language. .The voice (or subtitle) language cannot be changed when the DVD disc being played does not contain the recording of more than one voice (or subtitle) language. · 57 57 DVD / CD player unit Symptom Cause Remedy The viewing angle cannot be changed. .The DVD disc being played does not contain the recording of more than one angle. .You are attempting to switch the angle in a DVD section where more than one angle is not recorded. .The viewing angle cannot be changed when the DVD disc being played does not contain the recording of more than one angle. .More than one viewing angle may be recorded only in limited sections in a disc. § A disc can not be played although t...