Assessments - 4, GPA: 4.5
(
)
)
|
Facilidade de uso
Never use pipe dope. To achieve a leak-free thread connection, turn the male fitting until it is finger tight, then add one or two more turns. Over-tightening can cause splitting and failure of the female threads. A Important: Ensure the Y-Filter, Jar Top Valve and Pressure Regulator are installed in the correct flow orientation. Flow direction arrows are provided on each component. Refer to Figure 1 and Figure 2. 1. Using the Close Nipple, install the Ball Valve to the Jar Top Valve inlet. 2. Remove the Bonnet Ring from the Y-Filter by turning it counterclockwise. Remove the Bonnet and Filter Screen. See Figure 1. 3. Install the Y-Filter inlet to the Jar Top Valve outlet. 4. Install the Pressure Regulator inlet to the Y-Filter outlet. 5. Reassemble the Y-Filter components. Note: Hand tighten the Bonnet Ring only - do not over-tighten. A Important: Refer to the provided Toro Jar Top Valve, Anti-Siphon (AVB) installation instructions for additional important installation and operating information. 6. To determine the recommended minimum/maximum number of drip emitters per Jar Top valve, refer to the table below. Emitter (GPH) Low Flow 0.5 30-960 1.0 15—480 2.0 1-240 For technical assistance, call 1-800-367-8676. Specifications • Inlet/Outlet Pipe Connection: 3/4" Female NPT •Maximum Supply Pressure: 150 PSI •Downstream Pressure Regulation: 25 PSI • Flow Rate @ 25 PSI: 0.25-8 GPM • Filtration: 150 Count Stainless Mesh Screen • Irrigation Control Valve: •Automatic, Anti-Siphon, Toro Jar Top Model •Manual Bleed and Flow Control •24 V a.c., 60 Hz Solenoid Figure 1 Bonnet Ring Filter Screen Body Figure 2 Jar Top Valve Close Nipple Ball Valve Note: Valve must be installed at least 6" above the highest emitter it controls. Y-Filter From Water Supply }Úl i t © 2005 The Toro Company, Consumer Division • An ISO 9000-certified Company P.O. Box 489, Riverside CA, 92502 • Form Number 373-0347 Rev. B RELEASED Version ®Toro 2005-2005...