Assessments - 1, GPA: 4 ( )

Fabricante : Echo Arquivo Tamanho: 706.46 kb Arquivo Nome : Língua de Ensino:

Insure locator pin is fully engaged by gently twisting lower drive shaft. Locator pin (A) should snap flush in coupler. Full engagement will prevent further shaft rotation. 7. Secure lower shaft assembly to coupler by tightening clamping knob (D). InsTall handle/barrIer bar NOTE The Barrier Bar is required when using grass or weed blades. Units equipped with U-Handles do not require installation of the Barrier Bar. 1. Remove screws and nuts and back plate from handle. 4-screw front handles 2. Position front handle on shaft and install Barrier Bar using four (4) 5x35 mm screws and (4) new nuts included with kit. Handle must be at least 10 inches (250 mm) from center of rear handle grip. 3. Adjust handle position for comfortable operation, and tighten screws securely. 2-screw front handles 2. Position front handle on shaft and install Barrier Bar using two (2) 5x35 mm screws provided in kit. Handle must be at least 10 inches (250 mm) from center of rear handle grip. 3. Adjust handle position for comfortable operation, and tighten screws securely. NOTE The Barrier Bar is not a handle. blade InsTallaTIon Install Metal Shield 1. Loosely attach bracket (A) to shield (B) and attach to bottom of gear housing (C) with screws and nuts provided. Tighten all hardware. Install Blade 2. Install upper plate (D) on splined PTO shaft. Blade installation requires use of Upper Plate (D) with 20mm pilot. 3. Place Blade (E) over upper plate pilot, install the Lower Plate (F) and 10mm LH nut (G). 4. Insert Locking Tool (K) through hole in upper plate and notch in gear housing to prevent PTO shaft from turning. Tighten nut and secure with Split Pin (L). BLADE UPPER PLATE D balanCe unIT 1. Put on harness and attach unit to harness. 2. Slide harness clamp up and down until unit balances with head ap- proximately 2 - 3 in. from the ground. 3. Tighten clamp screw. NOTE In case of Emergency, the trimmer/brushcutter can be released from the the harness by pulling up on the quick-release collar. 2 - 3" balanCe unIT 1. Put on harness and attach unit to harness. 2. Slide harness clamp up and down until unit balances with head ap- proximately 2 - 3 in. from the ground. 3. Tighten clamp screw. NOTE In case of Emergency, the trimmer/brushcutter can be released from the the harness by pulling up on the quick-release collar. 2 - 3" operaTIon WARNING Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit. NOTE Refer to the Grass Trimmer / Brush Cutter Safety Manual for proper and safe trimming techniques. maInTenanCe WARNING Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop befor...

Baixe o seu

Para fazer o download, introduza 2 dígitos :