Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
Oil Capacity (Approximate amount when changing oil and filter.) Model Liters Ounces 050000 .4 13.5 085400, 086400 .6 20 117400 .7 24 118400 .7 24 138400 .9 32 184400, 185400, 187400 .9 32 235400, 237400, 245400, 246400, 247400 .9 32 Place engine level and clean around oil fill . Remove dipstick. and wipe with clean cloth. Insert dipstick in oil fill . tighten down if high oil fill , but do not tighten down if low oil fill . remove dipstick to check oil level. Oil should be at FULL mark . If oil is required, add slowly. Do not over-fill. Tighten dipstick firmly before starting engine. 2 FUEL RECOMMENDATIONS THE GASOLINE ENGINE IS CERTIFIED TO OPERATE ON GASOLINE. Exhaust Emission Control System: EM (Engine Modifications). Use clean, fresh, lead-free gasoline with a minimum of 85 octane. Leaded gasoline may be used if it is commercially available and if unleaded is unavailable. Purchase fuel in quantity that can be used within 30 days. See Storage. In U.S.A. leaded gasoline may not be used. Some fuels, called oxygenated or reformulated gasolines, are gasolines blended with alcohols or ethers. Excessive amounts of these blends can damage the fuel system or cause performance problems. If any undesirable operating symptoms occur, use gasoline with a lower percentage of alcohol or ether. Do not use gasoline which contains Methanol. Do not mix oil with gasoline. Check fuel level WARNING • Before refueling, allow engine to cool 2 minutes. Clean around fuel fill before removing cap to refuel. Fill tank to approximately 1-1/2 inches below top of neck to allow for fuel expansion. Be careful not to overfill. STARTING WARNING ALWAYS KEEP HANDS AND FEET CLEAR OF EQUIPMENT MOVING PARTS. WARNING • Do not use pressurized starting fluid. Vapors are flammable. Check oil level. Open fuel shut-off valve, if equipped. OIL GARD If engine is equipped with OIL GARD, and if engine runs low on oil and cannot be started or has stopped and cannot be restarted, add oil. Fill to FULL mark on dipstick. Do not over-fill. CAUTION: OIL GARD will shut down a running engine. Engine damage may occur if oil level is not properly maintained and will void warranty coverage. STARTING Fig. 3 1. Move choke control to CHOKE position. 2. Move throttle control to FAST position. 3. Turn on fuel shut-off valve . 4. Move stop control to ON position, if equipped. Rewind starter WARNING • Grasp rope handle and pull slowly until resistance is felt. Then pull cord rapidly to overcome compression, prevent kickback and start engine. Repeat if necessary with choke in RUN position and throttle in FAST. When engine starts, operate in FAST position. Electric starter, if equipped Turn key . to START position. Repeat if necessary with throttle control in FAST position. When engine starts, operate in FAST position. Note: If equipment manufacturer has supplied battery, charge it before trying to start engine, as equipment manufacturer recommends. Note: Use short starting cycles (15 secs. per min.) to prolong starter life. Extended cranking can damage starter motor. STOPPING Fig. 3 Do not move ...
Este manual também é adequado para os modelos :Canalização - 86400 (462.87 kb)
Canalização - 117400 (462.87 kb)
Canalização - 118400 (462.87 kb)
Canalização - 138400 (462.87 kb)