Assessments - 5, GPA: 4
(
)
)
|
Facilidade de uso
Insert Host Controller Driver Disk into CDROM. b. The Addonics Technologies Driver Disk window pops up. c. Select Configuration Utilities. Sil5744 SteelVine Manager. To extract the utility select your operating system from the list. d. Extract the files into your system. e. Install SiI5744 Manager by clicking the 5700Package.msi. Follow the instructions. f. After software installation, run the SteelVine Manager. The 57xx SteelVine Manager Utility manual can found in the Driver Disk under User Guides or can be downloaded from ers_Guide_Rev_1.0.pdf 2. Insert the CF cards to the CF slots on the AD2SAHDCF. 3. RAID Configuration. Note: SATA Connection: The act of connecting and disconnecting the SATA power cable serves as the RAID Setting button to confirm RAID mode setting. USB Connection: The act of connecting and disconnecting the USB cable serves as the RAID Setting button to confirm RAID mode setting. a. Set the switch to the RAID configuration required. RAID Settings Switch b. SATA Connection: Connect the SATA data and power cable to the AD2SAHDCF to confirm RAID mode setting. USB Connection: Connect the USB cable to the AD2SAHDCF to confirm RAID mode setting. c. Check in the 57xx SteelVine Manager if the RAID configuration is correct. 4. Once you have confirmed you had configured the correct raid set you want for the CF cards, you can then connect the AD2SAHDCF to a SATA port to be able to make it as a boot drive. Installing a fresh install of the operating system will be the same as installing it on a SATA hard drive. Steps to configure a SAFE RAID set using USB connection (Windows XP) Screenshot of Disk Management and 57xx SteelVine Manager showing CF card status 1. Open the 57xx SteelVine Manager. Initial unallocated CF card capacity Initial BIG RAID Setting 2. Insert the 2 CF cards to the CF slots on the AD2SAHDCF. 3. Connect the USB cable to the AD2SAHDCF. The 57xx SteelVine Manager CF cardsdetects the 2 CF cards in the AD2SAHDCF. CF cards New unallocated CF card capacity for SAFE RAID setting New SAFE RAID Setting *You will see an unallocated or partition depending if the CF card had been used. Delete the partition to make it into one BIG virtual disk. 4. Open Disk Management to check that both CF cards are detected. 5. Unplug the USB cable. 6. Place the switch to SAFE mode. 7. Plug back the USB cable to confirm the SAFE RAID setting. CF cards 8. To rebuild the SAFE RAID set, go to Action > Start Rebuild > Drive 1 Once Rebuild is done, this is the result. New SAFE RAID Setting Note: The steps for creating BIG or FAST RAID set would be similar with the steps on creating SAFE RAID set. Only select the correct switch setting. Technical Support If you need assistance to get your unit functioning properly, please call Addonics Technical Support. Our technical staff will be happy to assist you, but they will need your help to do so. Calling the technical support staff withou...
Este manual também é adequado para os modelos :Equipamento de rede - AD2SAHDCF (2.32 mb)
Equipamento de rede - AD2SAHDCF (2.32 mb)