Your operating system can always be upgraded to use FIR products. However you can never downgrade from an FIR product to an SIR product. Therefore make sure that you have not previously installed any other FIR products on your system. Followings are the instructions to properly install the ACT-IR220L+/220L/200L Dongle. You need a computer system with Windows 98 already installed and at least one serial port available. The best choice for the system is a desktop PC. A. Connect ACT-IR220L+/200L se

ACTiSYS Corp. 48511 Warm Springs Blvd, Suite 206 Fremont, CA 94539, USA TEL: (510) 490-8024, FAX: (510) 623-7268 E-Mail: irda-support@actisys.com Web: ....: IR-100M FCC & VCCI Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING-FCC Regulations state

15. Choose Print, the LED on IR100M+/IR100MP will be on and printer begin to print out. Or the parallel LED on the top of IR100M will flash and printer beginning to print out. If not, see Trouble Shooting. TROUBLE SHOOTING AND COMPATIBLE PRINTERS LIST For help on general and miscellaneous problems you may be experiencing with your printing, refer to the following pages for possible solutions. Look up your problem and try the solution. Note: Please Check your printer is on the IR-100M+/IR100M/IR1

IR100M adapter does provide two-way-communication capability and its returned signals are received but dropped by O.S. and therefore, not compatible with MFP. However, there are exceptions, such as Brother MFC4350 and other brands/models." IR100M series compatible with any interface of IEEE 1284 Type B. If printer is equipped with 2 interfaces, ONLY 1 interface could work each at time, both interfaces don’t work simultaneously. When your Printer connected to an USB port, the Parallel port will n

!"Do not expose the unit to extreme temperatures. It should not be placed in direct sunlight or in a closed vehicle, neither should it be placed near heaters nor other heat sources. !"Do not store the unit in a humid or dusty place. !"Use a soft, dry cloth to clean the unit. Do not use a wet cloth or any solvent. !"Do not drop the unit or handle the unit carelessly. CAUTION: !"Never touch the pins of computer connection terminal. The internal circuits can be damaged by a static electricity disch

Co., Ltd. All rights reserved. .2003/11 From 3JTech Revision 1.0 Page 1 of 41 PP2-5600 and PP2I-5600 User’s Manual TABLE TABLE............................................................................................2 I. INTRODUCTION.........................................................................3 II. 56K ACCESS INFORMATION...................................................4 III. HARDWARE INSTALLATION...................................................5 BEFORE YOU START ...............

0.12 © Copyright 2003-2004 ACTiSYS Corporation All Rights Reserved ....: Table of Contents INSTALLATION FOR ACT-IR8250SW.........................................................................................4 UNINSTALLATION FOR ACT-IR8250SW.................................................................................6 APPLICATION GUIDE...............................................................................................................................9 Main Window Layout...........

It is assumed that the user is familiar with the basic operation of Window 98/ME/2000/XP. PARTS CHECK LIST When you unpack the package, the following items should be found. 1. ACT-IR210L Adapter 2. 5 pins Motherboard Connector 3. User’s Guide 4. 5 pins to 6 pins changer SYSTEM REQUIREMENTS To use ACT-IR210L, your computer MUST meet the following requirements. 1. Window 98/ME/2000/XP. 2. Built in infrared I/O controller or super I/O chip on the motherboard with infrared connector available and do

1.0 © Copyright 2000-2006 ACTiSYS Corporation All Rights Reserved ....: TABLE OF CONTENTS REVISION HISTORY...............................................................................................3 PRECAUTIONS........................................................................................................4 1. FEATURES................................................................................................................5 2. OVERVIEW............................................

Copyright 2005-2006 ACTiSYS Corporation All Rights Reserved TABLE OF CONTENT REVISION HISTORY................................................................................................3 1. OVERVIEW................................................................................................................4 2. DRIVER REQUIREMENT........................................................................................4 3. BLUETOOTH PROFILE SUPPORTED...........................................