Assessments - 5, GPA: 4.4
(
)
)
|
Facilidade de uso
To help you do this please read the accompanying operating instructions. Keep these instructions in a safe place. If you pass the device on to anyone else, please ensure that you also pass on all the documentation. • Proper use The belt sander is designed for dry sanding of large surfaces of wood, plastic, metal, plaster and painted surfaces. The device may only be used for dry sanding. Always use a sanding belt and grade of grit suitable for the particular surface you are sanding. The speed selected should also be appropriate for the material. The device is not intended for commercial use. Any other use or modification to the device shall be considered as improper use and could give rise to considerable dangers. The manufacturer will not accept liability for loss or damage arising from improper use. • Features and equipment T Belt speed adjuster wheel T Locking knob _3_ ON / OFF switch _4_ Toothed belt cover 5 Dust extraction spout ~6_ Belt adjuster screw y Auxiliary handle T Ventilation slots _9_ Tensioning lever 10 Dust collection box TT Extraction adapter Fixed mounting kit: 12 Mounting frame 13 Clamp plates 2 x 14 Screw clamps 2 x 15 Spacer plates 2 x T6 Screw • Included items Check that all the items and accessories are present immediately after unpacking the device: 1 Belt sander PBS 900 A1 1 Sanding belt 6 GB/IE III PARKSIDE Introduction / General safety advice for electrical power tools 1 Dust collection box 1 Extraction adapter (for external vacuum dust extraction) 1 Fixed mounting kit 1 Operating instructions • Technical information Belt sander: Nominal voltage: Nom. power input: No-load belt speed: No-load speed: Sanding belt Protection class: Parkside PBS 900 A1 230 V ~ 50 Hz 900 W 180 - 340 m / min n0 345 - 645 min-1 75x533 mm II /H Noise and vibration data: Measured values for noise are determined in accordance with EN 60745. The A-weighted noise level of the electrical power tool are typically: Sound pressure level: 86 dB(A) Sound power level: 100 dB(A) Uncertainty K: 3 dB Wear ear protection! Total vibration, EN 60745: Vibration emission value ahD = 2,928 m / s2 Uncertainty K < 1.5 m / s2 HWaRNN {GJ The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circumstances. load over the whole of the period of working. The PBS 900 A1 belt sander has full-wave electronics with additional control electronics, soft start with inrush current limiting. A General safety advice for electrical power tools Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration HWaRNN ¡GJ Read all the safety advice and instructions! Failure to observe the safety advice and instructions may result in electric shock, fire and/or serious injury. Keep all the safety advice and instructions in a safe place for future reference! The term "electrical tool" used in the safety advice refers to elec...