Assessments - 4, GPA: 4
(
)
)
|
Facilidade de uso
No oil in tool 2. Lubricate the tool according to the lubrication instructions in this manual 3. Low air pressure 3a. Adjust the regulator on the tool to the maximum setting (If applicable) 3b. Adjust the compressor regulator to tool maximum while the tool is running free 4. Air hose leaks 4. Tighten and seal hose fittings if leaks are found 5. Pressure drops 5a. Be sure the hose is the proper size. Long hoses or tools using large volumes of air may require a hose with an I.D. of 1/2” or larger depending on the total length of the hose 5b. Do not use multiple number of hoses connected together with quick connect fittings. This causes additional pressure drops and reduces the tool power. Directly connect the hoses together 6. Regulator set too low 6. Adjust regulator until tool reaches maximum speed Moisture blowing out of tool 1. Water in tank 1. Drain tank. (See air compressor manual). Oil tool and run until no water is evident. Oil tool again and run 1-2 seconds 2. Water in the air lines/hoses 2a. Install a water separator/filter (PA2121). NOTE: Separators only work properly when the air passing through the separator is cool. Locate the separator/filter as far as possible from the compressor 2b. Install an air dryer 2c. Anytime water enters the tool, the tool should be oiled immediately Sander stops when applied to work surface Spindle lock is in the locked Unlock spindle (See Figure 1) position 3 Operating Instructions Limited Warranty 1. DURATION: From the date of purchase by the original purchaser as follows: PL1551 and PL1504 three (3) years, all other models one (1) year. 2. WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld / Scott Fetzer Company, 100 Production Drive, Harrison, Ohio, 45030, Telephone: (800) 543-6400. 3. WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other than for purposes of resale) of the Campbell Hausfeld product. 4. WHAT PRODUCTS ARE COVERED BY THIS WARRANTY: This Campbell Hausfeld sander. 5. WHAT IS COVERED UNDER THIS WARRANTY: Substantial defects in material and workmanship which occur within the duration of the warranty period with the exceptions below. 6. WHAT IS NOT COVERED UNDER THIS WARRANTY: A. Implied warranties, including those of merchantability and FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED FROM THE DATE OF ORIGINAL PURCHASE AS STATED IN THE DURATION. If this product is used for commercial, industrial or rental purposes, the warranty will apply for ninety (90) days from the date of purchase. Some States do not allow limitation on how long an implied warranty lasts, so the above limitations may not apply to you. B. ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL LOSS, DAMAGE, OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE, OR MALFUNCTION OF THE CAMPBELL HAUSFELD PRODUCT. Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. C. Any failure that results from an accident, pu...
Este manual também é adequado para os modelos :Máquinas e acabar - TL1005 (1.34 mb)
Máquinas e acabar - TL1118 (1.34 mb)
Máquinas e acabar - FHT504 (1.34 mb)
Máquinas e acabar - IFT218 (1.34 mb)