Assessments - 5, GPA: 4.2 ( )

Fabricante : Echo Arquivo Tamanho: 1.69 mb Arquivo Nome : 4166749.pdf Língua de Ensino:

Trim off excess. (Figure 4) 10. Fill the engine with oil to the level indicated on the dipstick. Fill the fuel tank with clean, fresh regular grade unleaded gasoline. SET-UP INSTRUCTIONS FIGURE 3 FIGURE 4 CONTROLS (BLOWER SHOWN WITH SUBARU EX40 ENGINE. OTHER ENGINES ARE SIMILAR.) SWITCH (A) Move to the “OFF” position to stop the engine. Move to the “ON” position before starting engine. THROTTLE (B) Controls engine speed and the amount of air being blown. CHOKE (C) Move to the “CHOKE” position to apply the choke. Move to the “RUN” position to remove the choke. FUEL SHUT OFF (D) Move to the “OFF” position to shut off the fuel whenever transporting the machine by trailer or truck or during storage. Move to the “ON” position before starting the engine. REMOTE HORIZONTAL DEFLECTOR LEVER (E) Move the lever forward to direct the flow of air down. Move the lever back to direct the flow of air up. LOCKING KNOB (F) Tighten the knob to lock the horizontal deflector in the desired position. Loosen to allow the deflector to be rotated with remote horizontal deflector lever. VERTICAL DEFLECTOR (G) Rotate the deflector to direct air discharge forward or to the side. HORIZONTAL DEFLECTOR (H) Directs air flow. Controlled by Remote Horizontal Deflector Lever E. May be locked in place with knob F. OPERATION / MAINTENANCE BEFORE STARTING THE ENGINE 1. Read the Operator Manual and Engine Manual. Become familiar with the controls, how each functions, and what it operates. 2. Check the engine oil level and add if necessary. 3 Fill the fuel tank with good quality, clean, unleaded regular gasoline (petrol). Use a funnel to avoid spilling. OPERATING INSTRUCTIONS Air flow can be directed to the side or front by the two-position vertical deflector. The front discharge position is used to remove debris from along walls, fences, etc. The side discharge position is used to form windrows or piles. The horizontal deflector directs air downward to “chisel” under wet, heavy leaves and litter. Air velocity is regulated by the throttle setting. To reduce windrowing or to blow over an obstacle, point deflector upward. To avoid blowing in an area, close deflector and reduce throttle setting. Slight changes in deflector position will have a big effect on air flow. Experiment until you find the best position for your needs. When clearing a yard or parking lot, a little time spent planning how to blow it off can greatly reduce the total clearing time. To stop the engine, move the throttle control to the slow position and switch the engine off. Stop the engine when moving from work site to work site. This will save fuel and prevent inadvertently blowing debris where you don’t want to. NOTE: When transporting the machine by truck or trailer, close the fuel valve. This avoids the possibility of flooding should any dirt get under the carburetor float needle. Leaving the valve open can allow severe flooding which may ruin the engine by diluting the oil. MAINTENANCE INSTRUCTIONS Stop engine an...

Baixe o seu

Para fazer o download, introduza 2 dígitos :