Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
To fit the shoulder strap (11), simply open the buckle on the strap and fit it through the hole provided on the housing of the blower/vac. Operation of the blower vac Prior to using the blower vac, ensure you have read and understood this instruction manual. Ensure you are wearing suitable clothing and also safety equipment like safety glasses, ear protection and a mask if necessary. Ensure the attachments to the blower vac are correctly fitted and adjusted. Be aware of other people and animals in the area where you are to be operating the blower vac. Turning the blower vac ON 1. Plug the power cord into an approved electrical extension cord, and turn the extension cord on. 2. Ensuring the blower/vac is directed in a safe direction, squeeze the trigger switch and the blower/vac will start. Be sure to be holding the blower vac firmly on start up. Turning the blower vac OFF To turn the blower vac “OFF”, release the trigger switch. IMPORTANT. After you have turned the blower vac off, do not leave the product until the blower vac has been fully disconnected from the electrical supply. Extension cord support WARNING. A damaged extension cord can cause electric shock or risk of fire. Please inspect the extension cord periodically. The appliance shall not be used if the extension cord is damaged, it must be replaced before operation. Use an extension cord suitable for outdoor with a maximum length of 30m. During use of the blower vac, the extension cord will continually be pulled as you move from one area to another. An extension cord support has been provided on the housing of the blower vac to assist in preventing the electrical connection between the extension cord and blower vac plug being forced apart. Note. The support is for the extension cord, and not the cable from the blower vac. 1. To fit the extension cord to the support, make a tight loop in the extension cord, approximately 300mm from the socket on the extension cord. 2. Fit the loop into the cord support (6) located on the underside of the blower/vac housing. 3. Push the loop all the way through the cord support (6) by approximately 25mm. Selecting the blowing operation 1. Move the selector lever (2) down. You will hear a loud click as it goes into place. Note. When the blow operation is selected, air is drawn up through the large blow/vac tube and then expelled at a much higher velocity in the lower cavity below the blow/vac tube. IMPORTANT. Ensure when the blow operation is selected the blower/vac is pointed, directed and used in a safe manner. Do not direct the air flow from this blower vac directly or indirectly towards another person. Selecting the vacuum operation 1. Push the selector lever (2) up. You will hear a loud click as it goes into place. Note. When the vacuum operation is selected, air and debris are drawn up through the large vac tube, and forced through the mulching impeller. The debris is mulched and then blown down into the collection bag. IMPORTANT. Always ensure the collection bag is correctly attached as per the “Fitting the collection bag” section in this manual. Important notes when using the blower/ vacuum selector lever Do not force the lever. The lever should move with very little resistance. If the lever is difficult to move, disconnect the power supply, remove the collection bag and ensure debris, dirt or mud has not jammed the lever. When selecting either of the operations, ensure the selector lever is fully in one position or the other, not half way. To empty the collection bag It is not necessary to remove the collection bag from the blower vac when the bag needs to be emptied. The rear of the bag is fitted with a full length zip. Simply open the zip and empty the contents. Ensure to close the zip prior to operating the blower vac. Tips for using your blower vac The following points may assist you in the operation of the blower vac. • Always try and vacuum dry leaves, cuttings or general garden debris. • Wet material is difficult to mulch and also can cause the blower vac to clog. • If the leaves etc. are damp, then use the blower vac in blow selection to pile the leaves etc. into one area, vac and mulch the leaves when dry. • Avoid using the vac on areas where there are stones, or other hard objects. These objects will damage the impeller of the blower vac. • It is also advisable not to allow the blower vac to pick up soil. Soil generally contains moisture and when combined with other garden debris can clog the blower vac. • The blower vac is not a garbage disposal unit. Do not attempt to mulch any material other than general garden debris. • For better performance and comfort, it is recommended the collection bag is emptied when it becomes approximately half full. This reduces the weight and also allows the vac operation to perform at its highest level. Maintenance and storage information Prior to cleaning or any maintenance, always ensure the power plug has been removed from the electrical power supply. When you h...
Este manual também é adequado para os modelos :Sistemas de ventilação - 2000W (895.17 kb)