Assessments - , GPA: ( )

Instruções de Operação Little Wonder, Modelo OPTIMAX 4/1/1970

Fabricante : Little Wonder
Arquivo Tamanho: 1.69 mb
Arquivo Nome :

Língua de Ensino:

O documento está colocado, por favor, espere

Baixe o seu Fechar

O documento está colocado, por favor, espere

Baixe o seu Fechar

-Pare el motor antes de dar servicio-La gente a mas durante la operacion. 4165977ADVERTENCIAAntes de comenzar: WARNINGThrown objects-Keep bystanders away. -Do not blow toward people or pets. -Do not blow toward items that may be damaged by flying debris. -Keep hands and feet away. -Stop engine and remove spark plug wire before servicing. -Do not operate without guards in place. Fan blades can cut/crush. DANGER4165975 4165913DEFLECTOR 4165913 USED ON REMOTE HORIZONTAL DEFLECTOR MODELS ONLY SET-UP INSTRUCTIONS SET-UP INSTRUCTIONS 1. Open box. Remove upper handle and cardboard insert. 2. Lay box down with blower housing up. Use lower handle to roll unit out of the box. 3. Locate hardware package. 4. Install upper handle to lower handle with (4) 3/8-16 x 1-34 carriage bolts and (4) 3/8-16 flanged nylon insert nuts from the hardware package. Tighten the nuts securely but not so much as to crush the tube. (Figure 1) 5. Route the throttle cable in front of lower handle crossbar. Install to the left side of the upper handle with (2) 10-32 x . thread forming screws from the hardware package. (Figure 2) 6. Ensure the center link of the chain is on the center tooth of the deflector sprocket before connecting the deflector cable. (Figure 5) FIGURE 1 FIGURE 2 FIGURE 5 SET-UP INSTRUCTIONS (continued) 7. Route the deflector cable above the axle and in front of the lower handle cross bar. Remove one of the nuts and the boot from the end of the deflector cable and install the cable through the key slot into the bracket on the upper handle. Reconnect the clevis from the control lever and install over the end of the cable. Reconnect the clevis to the control lever with a . x 5/8 clevis pin and hairpin cotter. (Note: The deflector can be moved and held in place with the locking knob to help connect the clevis fitting to the control lever. Move the control lever to the rear to more easily connect the cable. Loosen the knob so the deflector moves freely after the clevis is connected. (Figure 3) 8. Move the deflector control lever to the rear of the slot. Adjust the jam nuts on the cable fitting so the deflector is completely closed. Lock the nuts against the bracket when the adjustment is correct. 9. Secure the throttle and deflector cables to the handle tubes with cable ties from the hardware package. Trim off excess. (Figure 4) 10. Fill the engine with oil to the level indicated on the dipstick. Fill the fuel tank with clean, fresh regular grade unleaded gasoline. SET-UP INSTRUCTIONS FIGURE 3 FIGURE 4 CONTROLS (BLOWER SHOWN WITH SUBARU EX40 ENGINE. OTHER ENGINES ARE SIMILAR.) SWITCH (A) Move to the “OFF” position to stop the engine. Move to the “ON” position before starting engine. THROTTLE (B) Controls engine speed and the amount of air being blown. CHOKE (C) Move to the “CHOKE” position to apply the choke. Move to the “RUN” position to remove the choke. FUEL SHUT OFF (D) Move to the “OFF” position to shut off the fuel whenever transporting the machine by trailer o...