Log:
Assessments - 3, GPA: 4.3 ( )

Instruções de Operação Tanaka, Modelo THB-2500

Fabricante : Tanaka
Arquivo Tamanho: 513.37 kb
Arquivo Nome :
Língua de Ensino: en
Ir para baixar



Facilidade de uso


*Always move the unit at least 3 m (10 ft.) from the fueling area before starting. Before fueling, clean the tank cap area carefully, to ensure that no dirt falls into the tank. Make sure that the fuel is well mixed by shaking the container, before fueling. 5 custsvc@tanaka-ism.com Owner.s ManualTHB-2500/THB-2510/TBL-4600/4610,TBL-505 THB-2500/THB-2510/TBL-4600/4610,TBL-505 Starting CAUTION! Do not start if the pipe is obstructed by the ground or any other object. 1 .Set ignition switch (1) to ON position. (Fig. 2-2, 2B, 2C) . Push priming bulb (4) several times so that fuel flows through return pipe (5) (if so equipped) (Fig. 2-3, 3B) . Move throttle lever to a half-open position (2) and lock it with lock lever (4) (if so equipped), when it is hard to start engine. (Fig. 2-2C) Note! (TBL-4610) Model TBL-4610 does not have an ignition switch. To start or to stop the unit, ignore the switch operation from procedures in the manual. However, when starting the unit, move throttle lever to START position. 2. Set choke lever to CLOSED position (4). Fig. 2-4, 4B 3. Pull recoil starter briskly, taking care to keep the handle in your grasp and not allowing it to snap back. (Fig. 2-5, 5B) 4. When you hear the engine want to start, return choke lever to RUNposition (open). Then pull recoil starter briskly again. NOTE! If engine does not start, repeat procedures from 2 to 4. 5. After starting engine, allow the engine about 2-3 minutes to warm upbefore subjecting it to any load. 6 custsvc@tanaka-ism.com Owner.s ManualTHB-2500/THB-2510/TBL-4600/4610,TBL-505 THB-2500/THB-2510/TBL-4600/4610,TBL-505 Operating blower (Fig. 2-6, 6B) Adjust shoulder harness to fit your stature before operating unit. Back-pack unit in a correct way. (Fig. 2-6B) WARNING! Do not direct discharge of air toward people or pet. 1. The unit should be operated in a well ventilated area. 2. A low speed should be used to blow leaves and dry grass. 3. A medium speed should be used to clean wet leaves and grass. 4. A high speed should be used when moving gravel, dirt or other heavy materials. CAUTION! This blower has been designed and adjusted to be used with all blower pipes attached (See page 1). It must never be operated without the straight pipe, and blow head. Stopping (Fig. 2-7, 7B, 7C) Decrease engine speed, and push ignition switch to stop position. Note! (TBL-4610) Model TBL-4610 does not have an ignition switch. To stop the unit, move throttle lever to START position and run for a few minutes, then move the lever further to STOP position. 7 custsvc@tanaka-ism.com Owner.s ManualTHB-2500/THB-2510/TBL-4600/4610,TBL-505 THB-2500/THB-2510/TBL-4600/4610,TBL-505 5. Maintenance MAINTENANCE, REPLACEMENT, OR REPAIR OF THE EMISSION CONTROL DEVICES AND SYSTEM MAY BE PERFORMED BY ANY NONROAD ENGINE REPAIR ESTABLISHMENT OR INDIVIDUAL. Carburetor adjustment (Fig. 3-1, 1 B, IC) In the carburetor, fuel is mixed with air. When the engine is test run at the factory, the carburetor is basically adjusted. A further adjustment may be required, according to climate and altitude. The carburetor has one adjustment possibility: T = Idle speed adjustment screw. Idle speed adjustment (T) To adjust, turn IDLE Adjustment Screw (T) in (clockwise) to increase engine speed, out (counterclockwise) to decrease engine speed. Standard Idle rpm is 2500-3000rpm. CAUTION! The above adjusting procedure must be followed when adjustment is MADE or DAMAGE to engine will occur because of the incorrect condition. RECOMMENDATION: CARBURETOR ADJUSTMENT NEEDS THE SKILL OF EXPERIENCED OR WELL TRAINED PEOPLE. IT IS RECOMMENDED TO TAKE THE UNIT TO YOUR NEAREST DEALER. 8 custsvc@tanaka-ism.com Owner.s ManualTHB-2500/THB-2510/TBL-4600/4610,TBL-505 THB-2500/THB-2510/TBL-4600/4610,TBL-505 Air filter The air filter must be cleaned from dust and dirt in order to avoid: . Carburetor malfunctions. . Starting problems. . Engine power reduction. . Unnecessary wear on the engine parts. . Abnormal fuel consumption. Remove the air cleaner cover...

Este manual também é adequado para os modelos :
Sistemas de ventilação - TBL-4610 (513.37 kb)
Sistemas de ventilação - THB-2510 (513.37 kb)
Sistemas de ventilação - TBL-4600 (513.37 kb)
Sistemas de ventilação - TBL-505 (513.37 kb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias