Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
This engine is certified to operate on unleaded gasoline intended for automotive use with an octane rating of 87 ([R + M] / 2) or higher. Do not use automotive oil or 2-cycle outboard oil. NOTE: Premium Exact Mix™ fuel mixture will stay fresh up to 30 days. DO NOT mix quantities larger than usable in a 30 day period. PREMIUM EXACT MIX™ (50:1) GASOLINE OIL 1 Gallon (US) 2.6 oz. 1 Liter 20 cc (20 ml) FILLING THE TANK WARNING: Always stop the engine before filling the fuel tank. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. (9 m) from the refueling area before starting engine. Do not smoke while filling the tank. ¦ ¦¦¦¦¦Clean the surface around the fuel cap to prevent contamination. ¦ ¦¦¦¦¦Loosen the fuel cap slowly, by turning it counterclockwise. ¦ ¦¦¦¦¦Pour the fuel mixture carefully into the tank. ¦ ¦¦¦¦¦Clean and inspect the fuel cap gasket before replacing the fuel cap. ¦ ¦¦¦¦¦Replace the fuel cap and tighten it by turning it clockwise. ¦ ¦¦¦¦¦Wipe spilled fuel from the product. ¦ ¦¦¦¦¦Move at least 30 ft. (9 m) away from refueling area before starting the product. NOTE: It is normal for smoke to be emitted from a new engine during first use. WARNING: Check for fuel leaks. If you find any leaks, correct the problem before using the product. Failure to do so could result in a fire that could cause serious personal injury. WARNING: A leaking fuel cap is a fire hazard and must be replaced immediately. Failure to do so could result in a fire that could cause serious personal injury. Page 10 OPERATION STARTING AND STOPPING See Figures 8 - 9. TO START: ¦ ¦¦¦¦¦Place the blower on a flat bare surface. ¦ ¦¦¦¦¦Set switch to ON (I). ¦ ¦¦¦¦¦Squeeze the throttle trigger fully and hold. Press trigger lock lever down and release throttle trigger. ¦ ¦¦¦¦¦Slowly press the primer bulb seven (7) times. ¦ ¦¦¦¦¦Move the choke lever to the FULL CHOKE position. ¦ ¦¦¦¦¦Pull the starter handle sharply until engine attempts to run. Do not pull the starter handle more than eight (8) times. ¦ ¦¦¦¦¦Move the choke lever to the HALF CHOKE position. ¦ ¦¦¦¦¦Pull the starter handle until the engine runs. Do not pull the starter handle more than six (6) times. ¦ ¦¦¦¦¦Allow the engine to run 15 seconds, then set the choke lever to the RUN position. Squeeze the throttle trigger to release the trigger lock. TO STOP: Set the switch to OFF (O). TO REMOVE BLOWER: ¦ ¦¦¦¦¦Move harness straps off the shoulders, let straps slide down arms. ¦ ¦¦¦¦¦Grasp the straps and lower the blower to the ground. WARNING Do not allow familiarity with your product to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. OPERATING THE BLOWER See Figure 10. ¦ Start the blower, refer to “Starting and Stopping” later in this manual. Slip arm through harness strap and onto shoulder, then repeat for the other shoulder. Adjust the straps to a comfortable position, refer to “Adjusting Harness Straps” earlier in this manual. Operate the blower from the right side as shown in illustration. ¦ To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile. ¦ To reduce sound levels, limit the number of pieces of equipment used at any one time. ¦ Operate blower at the lowest possible throttle speed to do the job. ¦ Check your equipment before operation, especially the muffler, air intakes and air filters. ¦ Use rakes and brooms to loosen debris before blowing. Fig. 10 AIRFILTERAIRFILTER Fig. 8 TRIGGER LOCK THROTTLE TRIGGER Fig. 9 PRIMER BULB CHOKE LEVER FULL CHOKE RUN SWITCH SWITCH HALF CHOKE Page 11 Page 12 OPERATION MAINTENANCE WARNING: When servicing use only identical manufacturer's replacement parts. Use of any other parts may create a hazard or cause product damage. REPLACING AND CLEANING THE AIR FILTER See Figure 11. For proper performance and long life, keep air filter clean. ¦ Pivot the air filter cover down by pushing down on the latch with your thumb while gently pulling on the cover. ¦ Remove the filter. Clean it in warm soapy water. Rinse and let dry completely. For best performance, replace annually. ¦ Install the filter. Pivot the cover into place ensuring the latch snaps and latches into place. Fig. 11 AIR FILTER BASE AIR FILTER COVER ¦ In dusty conditions, slightly dampen surfaces when water is available. ¦ Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches and gardens. ¦ Watch out for children, pets, open windows or freshly washed cars, and blow debris safely away. ¦ Use the nozzle for larger volume, so the air stream can work close to the ground. ¦ After using blowers or other equipment, CLEAN UP! Dispose of debris properly. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal...
Este manual também é adequado para os modelos :Sistemas de ventilação - BACKPACKER II UT08570 (1.2 mb)