Assessments - 4, GPA: 4
(
)
)
|
Facilidade de uso
IMPROPER OPERATION CAN CAUSE SERIOUS INJURY. CAUTION \ DO NOT REMOVE IMPELLER 5 COVER WHILE MACHINE IS V RUNNING. SEVERE INJURY i WILL RESULT. 5 TJFJrjrjr.ArW.WJTJF; PART NO. 091-0059 CAUTION ! |1) READ OPERATING INSTRUCTIONS THOROUGHLY BEFORE USING. A (2) DAN6ER: Rotating parts. Keep hands, feet, and clothing out of openings at all a times and especially while machine is running. y ~ (3) NEVER operate with the impeller housing cover removed. ^ (4) NEVER direct the discharge air stream towards any persons, children, or animals. A (5) Stop engine and disconnect spark plug wire before attempting to clean the intake a screen or discharge chute. y (6) Do not use this machine for any purpose other than that for which intended. ^ PART NO. 091-0058 SNAPPER * 1189 Old Schuylkill Road * P.O. Box 111 * Parker Ford, PA 19457-0111 PHONE: (215) 495-7181 * * * FAX: (215) 495-5951 Form SLB862 693 LEAF BLOWER OWNER’S MANUAL Assembly Instructions Your leaf blower has been carefully packed at the factory. Before proceeding with assembly, make sure all parts have been received and are in good condition. If there are shortages or damage, report it immediately to the company from whom you obtained the machine. (Note: In the following Instructions, the item number refers to the number encircled for that part on the drawing, page 3.) 1. Locate the two large rubber handle washers (item 6) and slide them onto the upper handle, one on each side. 2. Insert the upper handle into the lower square tube handle. Note that there are three holes in each side of the upper handle. These are height adjustment holes. Position the upper handle at a comfortable height for you (usually waist high). Move the upper handle up or down slightly to align the hole in the upper handle and lower handle. Locate the upper lifting handle (item 4) and with the hardware provided, bolt through the upper lifting handle, lower and upper handle. Tighten securely. 3. Attach the throttle control to the upper handle as per the drawing. 4. Place the front wheel (item 41) into the front wheel bracket (item 38). Insert the shoulder bolt (item 39) - through the front wheel bracket and wheel and hold in place with the 3/8-16 Grip Co lock nut (item 42). NOTE: The front wheel bracket (item 38) provides two different discharge height adjustments by turning the bracket over. The total discharge height adjustment is 1-1/4". 5. Service the engine as recommended by the manufacturer. Fill the fuel tank with lead-free or low-lead gasoline. 6. Familiarize yourself with the operating instructions before attempting to use your blower Operating Instructions 1. For maximum air speed, run the engine with throttle wide open in the "FAST" position. 2. To change air flow from side to front, simply pull diverter handle back to direct air flow to the side and push handle forward to direct air flow to the front. 3. Never direct the discharge air stream toward any observers, children, pets or fragile ob...
Este manual também é adequado para os modelos :Sistemas de ventilação - SLB862 (185.77 kb)
Sistemas de ventilação - SLB862IC (185.77 kb)
Sistemas de ventilação - SLB862IC (185.77 kb)