Assessments - 3, GPA: 4.3
(
)
)
|
Facilidade de uso
Mix Homelite Premium Exact Mix lubricant with gasoline according to the instructions on the package. If Premium Exact Mix lubricant is not available, use a high quality synthetic 2-cycle engine lubricant, mixed at 2.6 oz. per gallon (US). Do not use automotive lubricant or 2-cycle outboard lubricant. NOTE: Premium Exact Mix fuel mix will stay fresh up to 30 days. DO NOT mix quantities larger than usable in a 30 day period. • Position the product on its side with the fuel cap pointing upward. • Clean surface around fuel cap to prevent contamination. • Loosen fuel cap slowly. Rest the cap on a clean surface. • Carefully pour fuel into the tank. Avoid spillage. WARNING: Do not allow familiarity with product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. OPERATION FILLING TANK • Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage. NOTE: It is normal for smoke to be emitted from a new engine after first use. WARNING: Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. from refueling site before starting engine. Do not smoke! PREMIUM EXACT MIX (50:1) GASOLINE LUBRICANT 1 gallon (US) 2.6 oz. 1 liter 20cc (20 ml) Page Page 10 STARTING AND STOPPING See Figures 4 - 6. Starting the product differs depending on whether the engine is cold or warm. Blower should be on a flat, bare surface for starting. TO START A COLD ENGINE: . Place the throttle/stop lever in the high speed ( ) position. . Slowly press the primer bulb seven (7) times. . Rotate the choke dial clockwise to the FULL CHOKE position. . Pull the starter grip sharply until engine attempts to run (no more than 4 pulls). . Rotate the choke dial to the counterclockwise HALF CHOKE position. . Pull the starter grip sharply until the engine runs. . Allow the engine to run for 10 seconds. . Rotate the choke dial counterclockwise to the RUN position. . Turn throttle/stop lever to desired speed. NOTE: Move the throttle/stop lever to the ( ) position to run the blower at high speed. Move the throttle/stop lever to the ( ) position to run the blower at low speed. Blower speed decreases as the switch is moved closer to the low speed position and increases when the switch is moved closer to the high speed position. TO START A WARM ENGINE: . Rotate the choke dial counterclockwise to the RUN position. . Place the throttle/stop lever in the high speed ( ) position. . Slowly press the primer bulb seven (7) times. . Pull the starter grip sharply until the engine runs. TO STOP THE ENGINE: See Figure 6. Place the throttle/stop lever in the STOP (OFF) position. if assistance is re quire d STARTING THIS product: Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have. For Help Call: 1-800-242-4672 WARNING: Keep away from all hot surfaces of the blower. Failure to do so could result in possible serious personal injury. Fig. 6 operation Fig. 5 Fig. 4 PRIMER BULB STOP (OFF) POSITION full CHOKE half CHOKE run THROTTLE/ STOP LEVER choke dial HIGH SPEED LOW SPEED Page 11 OPERATING the blower See Figures 7 - 8. ¦WARNING: Always hold the blower away from your body with the handle in your right hand, keeping clearance between your body and the product. Any contact with the housing can result in burns and/or other serious personal injury. . To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile. . Operate power equipment at reasonable hours only — not early in the morning or late at night when people might be disturbed. Comply with the times listed in local ordinances. ¦. To reduce sound levels, limit the number of pieces of equipment used at any one time. ¦¦. Operate blower at the lowest possible throttle speed to do the job. ¦¦. Check your equipment before operation, especially the muffler, air intakes, and air filters. ¦¦. Use rakes and brooms to loosen debris before blowing. ¦. In dusty conditions, slightly dampen surfaces when water is available. ¦¦. Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches, and gardens. ¦. Watch out for children, pets, open windows, or freshly washed cars, and blow debris safely away. ¦. Use the full blower nozzle extension so the air stream can work close to the ground. ¦. After using blowers or other equipment, CLEAN UP! Dispose of debris in trash receptacles. Caution: Do not place blower on top of or near loose debris. Debris may be sucked into blower intake vent resulting in possible damage to the unit. operation Fig. 7 proper operating position Fig. 8 intake vent Page 12 maintenance WARNING: When servicing, use only identical Homelite replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Always wear safety ...