Assessments - 4, GPA: 4 ( )

Fabricante : Datalogic Scanning Arquivo Tamanho: 2.73 mb Arquivo Nome : Língua de Ensino:

DS6500-100-0XX CONDITIONS Code = Interleaved 2/5 or Code 39 PCS = 0.90 Pitch angle = 0° Skew angle = 10° - 20° Tilt angle = 0° 0 4(in)812160 1020304050(cm)60202480 32 (in) (cm) 0-10-20-30-8 -12 -4 0 -40-16 -50-20 104 208 0.25 mm (10 mils) 0.3 mm (12 mils) 90 36 100 40 70284016 5020 3012 0.375 mm (15 mils) DS6500-105-0XX CONDITIONS Code = Interleaved 2/5 or Code 39 PCS = 0.90 Pitch angle = 0° Skew angle = 10° - 20° Tilt angle = 0° 0 4(in)812160 1020304050(cm)60202480 32 (in) (cm) 0-10-20-30-8 -12 -4 0 -40-16 -50-20 104 208 0.25 mm (10 mils) 0.3 mm (12 mils) 90 36 100 40 70284016 5020 3012 0.375 mm (15 mils) Reading Diagrams: DS6500-200-0XX CONDITIONS Code = Interleaved 2/5 or Code 39 PCS = 0.90 Pitch angle = 0° Skew angle = 10° - 20° Tilt angle = 0° 0 14(in)2026320 3550658095(cm)1103844140 56 (in) (cm) 0-15-30-45-12 -18 -6 0 -60-24 -75-30 156 3012 0.5 mm (20 mils) 155 62 170 68 125506024 7530 4518 0.375 mm(15 mils) DS6500-205-0XX CONDITIONS Code = Interleaved 2/5 or Code 39 PCS = 0.90 Pitch angle = 0° Skew angle = 10° - 20° Tilt angle = 0° 0 14(in)2026320 3550658095(cm)1103844140 56 (in) (cm) 0 -15-30-45-12 -18 -6 0 -60-24 -75-30 156 3012 0.5 mm (20 mils) 0.375 mm(15 mils) 155 62 170 68 125506024 7530 4518 User Interface: RS232 PC-side connections 1 5 9 6 9-pin male connector 13 25 141 25-pin male connector Pin Name Pin Name 2 RX 3 RX 3 TX 2 TX 5 GND 7 GND 7 RTS 4 RTS 8 CTS 5 CTS How To Build A Simple Interface Test Cable: The following wiring diagram shows a simple test cable including power, external (push-button) trigger and PC RS232 COM port connections. 25-pin D-sub female23 20 GND RXAUX TXAUX 21 DS6500 25 13 GND VS 9-pin D-sub female GND TX RX PC 2 3 5 18 9 EXT TRIG AVS Power SupplyVS (15 – 30 VDC) Power GND Trigger EXT TRIG B19 Compliance: Laser Safety Figure A Laser Safety Label 1 Identification Label 2 Figure B Warning and Device Class Label1 Figure C Laser Safety Label 1 The scanner is classified as a Class 2 laser product according to EN 60825-1 regulations and as a Class II laser product according to CDRH regulations. Disconnect the power supply when opening the device during maintenance or installation to avoid exposure to hazardous laser light. There is a safety device which allows the laser to be switched on only if the motor is rotating above the threshold for its correct scanning speed. The laser beam can be switched off through a software command (see also the Genius™ Help On-Line). AVOID EXPOSURE LASER RADIATION IS EMITTED FROM THIS APERTUREAVOID EXPOSURE – LASER LIGHT IS EMITTED FROM THIS APERTURE Laser Safety Label for Oscillating Mirror and Standard Models CAUTION-CLASS 3B LASER LIGHT WHEN OPEN AVOID EXPOSURE TO BEAM LASER LIGHT – DO NOT STARE INTO BEAM CLASS 2 LASER PRODUCT MAX. OUTPUT RADIATION 1 mW EMITTED WAVE LENGTH 630 ~ 680 nm EN60825-1:2001 N2468DATALOGIC S.p.A. Via Candini, 2 40012 LIPPO DI CALDERARA DI RENO (BO) ITALY MANUFACTURED VOLT Amp. JANUARY 2002 15-30 DC 1.5-0.7 MODEL No. SERIAL No. This product conforms to the applicable requirements of 21CFR 1040 at the date of manufacture. Warning and Device Class Label Device Identification Label Casella di testo: 1 Casella di testo: 2 Casella di testo: 1 Casella di testo: 1 The laser diode used in this device is classified as a Class 3B laser product according to EN 60825-1 regulations and as a Class IIIb laser product according to CDRH regulations. As it is not possible to apply a classification label on the laser diode used in this device, the following label is reproduced below: LASER LIGHT AVOID EXPOSURE TO BEAM CLASS 3B LASER PRODUCT MAXIMUM OUTPUT RADIATION 35 mW EMITTED WAVE LENGTH 630~680 nm TO EN60825-1 (2001) Laser Diode Class Label Any violation of the optic parts in particular can cause radiation up to the maximum level of the laser diode (35 mW at 630 ~ 680 nm). Power Supply - This product is intended to be installed by Qualified Personnel only. - All DS6500 Models: This device is intended to be supplied by a UL Listed Power Unit marked “Class 2” or LPS power source which supplies power directly to the scanner via the 25/26-pin connector. WEEE Compliance DATALOGIC S.p.A., DATALOGIC S.p.A., Via Candini, 2 Via Candini, 2 40012 - Lippo di Calderara 40012 - Lippo di Calderara Bologna - Italy Bologna - Italy dichiara che dichiara che declares that the declares that the declare que le declare que le bescheinigt, da. das Gerat bescheinigt, da. das Gerat declare que el declare que el DS6500-XXX-XXXDS6500-XXX-XXX, Laser Scanner e tutti i suoi modelli and all its models et tous ses modeles und seine modelle y todos sus modelos sono conformi alle Direttive del Consiglio Europeo sottoelencate: are in conformity with the requirements of the European Council Directives listed below: sont conformes aux specifications des Directives de l'Union Europeenne ci-dessous: der nachstehend angefuhrten Direktiven des Europaischen Rats: cumple con los requisitos de las Directivas del Consejo Europeo, segun la lista siguiente: 89/336/EEC EMC Di...

Baixe o seu

Para fazer o download, introduza 2 dígitos :