Assessments - 1, GPA: 5
(
)
)
|
Facilidade de uso
Contents Introduction Installation Product Specification For your Safety – Always For your Safety – Never Features EW51 Control Panel General Information Notes (Ceramic Hobs) 10-13 Temperature Conversion Scale Top Oven/Grill Cookery Notes Grill Pan and Handle Solar Plus Grill Guide to Grilling Oven Temperature Chart – Meat Oven Temperature Chart – Baking Main Oven Cookery Notes 21-22 Recipes 23-25 Care and Cleaning 26-27 Cooking Results Not Satisfactory Something Wrong with your Cooker Spares and Key Contacts 30 and Rear cover Introduction Your new appliance is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet. To help make best use of your cooking equipment, please read this booklet carefully. The cooker is designed specifically for domestic use and responsibility will not be accepted for use in any other installation. When the cooker is first used an odour may be emitted, this will cease after a period of use When first using the cooker ensure that the room is well ventilated (e.g. open a window or use an extractor fan) and that persons who may be sensitive to the odour avoid any fumes. It is suggested that any pets be removed from the room until the smell has ceased. This odour is due to temporary finish on oven liners and elements and also any moisture absorbed by the insulation. * The guarantee is subject to the provisions that the appliance: (a) Has been used solely in accordance with the Users Instruction Book. (b) Has been properly connected to a suitable supply voltage as stated on the rating plate attached to this equipment. (c) Has not been subjected to misuse or accident or been modified or repaired by any person other than the authorised employee or agent. (d) Has been correctly installed. This appliance conforms to the following EEC Directives: Electromagnetic Compatibility Low Voltage Equipment 89/336/EEC 73/23/EEC 92/31/EEC 93/68/EEC 93/68/EEC Installation Siting the Cooker 150 mm 150 mm650 mm WARNING – THIS APPLIANCE MUST BE EARTHED. Your cooker should have been checked to ensure that the voltage corresponds with your supply voltage, this is stated on the rating plate, which is situated on the front of the plinth. The cooker must be connected by a competent person eg. (NICEIC registered contractor) to suitable double-pole control unit with a minimum rating of 45A and a minimum contact clearance of 3mm, which should be fitted adjacent to the cooker, in accordance with IEE regulations. The power supply cable should conform to B.S.6004 with a conductor size of 6mm2 minimum. The control unit should be easily accessible in the event of an emergency, but must be within 2 metres of and not directly above an appliance. This appliance conforms to EN 55014 regarding suppression of radio and television interference. Access to the mains terminals is gained by removing the rear access cover. The mains cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable should be used to allow the cooker to be pulled out for servicing. Ensure that the mains cable is routed away from any brackets affixed to the rear panel and is not trapped to the rear wall when pushing the cooker into position between cabinets. The height of the cooker can be adjusted by means of adjustable feet in the plinth (900mm - 915mm). Adjust the feet by tilting the cooker from the side. Then install the product into position. The cooker is designed to fit between kitchen cabinets spaced 500mm apart. The space either side need only be sufficient to allow withdrawal of the cooker for servicing. It can be used with cabinets one side or both as well as in a corner setting. It can also be used free-standing. This cooker is a class X appliance, as such adjacent side walls which project above hob level, must not be nearer to the cooker than 150mm and should be protected by heat resistant material. Any overhanging surface or cooker hood should not be nearer 650mm. Never mount the cooker onto a platform. Installation Moving the Cooker Splash PanelKit (Wall Mounted) Before moving your cooker check that it is cool, and switch off at the cooker control unit. Movement of your cooker is most easily achieved by lifting the front as follows: Open the grill door sufficiently to allow a comfortable grip on the underside front edge of the oven roof, avoiding any grill elements. Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor covering is not damaged. Splashplate optional, apply to Hotpoint Spares Department. Product Specification Supply Voltage 230V AC Only 240V AC Only Supply Frequency 50Hz 50Hz Total Wattage 10.3kW 11.2kW Grill Wattage 2.4kW 2.6kW Top Oven Wattage 1.7kW 1.85kW Main Oven Wattage 2.3kW 2.5kW Left Front Hotplate 1.65kW 1.8kW Left Rear Hotplate 1.1kW 1.2kW Right Rear Hotplate 1.65kW 1.8kW Right Front Hotplate 1.1kW 1.2kW Grilling Area 900cm2...