Assessments - 3, GPA: 4.7 ( )

Fabricante : Craftsman Arquivo Tamanho: 1.74 mb Arquivo Nome : Língua de Ensino:

Shake fuel container each time before filling fuel tank. • Never use “stale” fuel left over from last season or stored for long periods. • DO NOT USE MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40. PROPER FUEL MIXING PROCEDURE 1. Fill approved clean fuel container one quarter full with fresh unleaded fuel - one quart (one liter) in a one gallon (4 liter) container. 2. Pour recommended amount of high quality two cycle oil — 2.5 ounces (80 ml) into fuel container for one gallon (4 liters) of fuel. (NOTE: DO NOT USE MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40.) 3. Reinstall cap on the fuel container and shake container vigorously so oil mixes with gasoline. 4. Unscrew cap and fill container with fuel. Shake container again. 5. Remove fuel tank cap and carefully pour mixed fuel into the fuel tank, filling to 1/2 inch (1.5 cm) below filler neck to allow room for expansion. Never put plain, unmixed fuel into fuel tank. Shake fuel container each time before filling fuel tank. Controls & Operation FUEL TO OIL MIXTURE CHART (50:1) U.S. Imperial Metric Gasoline Gallons 2 Cycle Oil Ounces Gasoline Gallons 2 Cycle Oil Ounces Gasoline Liters 2 Cycle Oil Milliliters 1 2 5 2.5 5 13 1 2 5 2.8 5.6 14.1 4 8 20 80 ml 160 ml 400 ml WARNING Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is hot or running. Always move outdoors to fill the tank. Keep snowthrower and gasoline away from open flame or spark. Figure 6. Proper Fuel Mixing Procedure A. Fill Container with 1 Quart (1 Liter) of fuel B. 2.5 Ounces (80 ml) of two-cycle oil C. Combine in container, then shake container D. Additional fuel brings total to 1 Gallon (4 liters) A B DC 9 Controls & Operation STARTING THE ENGINE NOTE: The snow thrower engine is designed to operate at cold temperatures. Avoid operating the snow thrower if air temperature is 40° C or warmer since engine may vapor lock and stop running after a short time. Engine DANGER Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains CARBON MONOXIDE, an ODORLESS and DEADLY GAS. will be difficult to start in warm weather. Electric Starting Steps Note: The electric starter is designed to operate on 120V AC household current, using power cord supplied with electric start snow thrower. When using power cord, match wide blade of plug to wide slot of receptacle. 1. Insert engine key in switch and turn key to the ON position. 2. If engine is cold, move choke control lever to the ON position. (Do not choke a warm engine). 3. Push the Primer Button two times if engine is cold. (Do not prime a warm engine.) 4. Plug power cord for starter into receptacle on starter switch, then plug other end into a 120Volt AC household receptacle. DO NOT use an extension cord with the electric start power cord supplied. CAUTION Be sure there is no moisture present on cord ends or receptacles when plugging cord into receptacle. 5. Push starter button to crank engine. DO NOT crank engine for m...

Baixe o seu

Para fazer o download, introduza 2 dígitos :