Assessments - , GPA:
(
)
)
Fabricante : Bosch
Arquivo Tamanho: 1.36 mb
Arquivo Nome :
Língua de Ensino: 
O documento está colocado, por favor, espere
 |
O documento está colocado, por favor, espere
Facilidade de uso
This will start the juicing operation and cut the whole orange in half. Juice will flow into container (8) below. The appliance will not operate by pressure on one cone (3) only - both cones must be loaded with fruit. 7. When halves are fully juiced, discard peel and repeat steps 5 & 6 until the juice container (8) is full (approximately 500 ml.). Do not fill above the max. fill line. 8. Slide out the juice container (8) to serve the juice. The removable sieve (9) will strain the excess pulp and any pips from the juice. If you prefer a higher fibre drink, simply remove the sieve. The drip tray (10) will catch any juice remaining in the juicing chamber (5). It is recommended to rinse the cones (3) and juicing chamber (5) periodically when preparing large quantities of oranges. If the Juicer stops operating during juicing, remove the cones (3) and rinse the juicing chamber (5) to remove excess pips which may lodge underneath the cones (3) and prevent the unit from operating. DISASSEMBLING 1. Slide out juice container (8) and drip tray (10). 2. To remove lid (1), open fully and apply pressure with thumbs as shown in Figure 2. Lid (1) will unclip from the juicing chamber together. 3. To prevent juice from dripping, remove the cones (3) and juicing chamber (5) together, operating the front lever (13). 4. Hold motor base (7) with one hand, and with the other grasp the juicing chamber (5) at the front and pull up over the drive shafts (6). The cones (3) will lift off with the juicing chamber (5) as shown in Figure 3. The cones (3) may also be removed separately from the juicing chamber (5) by simply lifting them off the drive shafts (6). 5. The juice drip tray (10) simply slides out for cleaning. CLEANING All removable parts may be washed by hand in hot soapy water. All the detachable parts are dish washer safe. Due to the strong natural colourings in the peel of citrus fruits, the juicing chamber (5) may discolour. To clean, spread the affected area with a thick paste of bicarbonate of soda and water. Allow to stand overnight and wash in hot soapy water. Do not place parts in harsh cleaning agents which may adversely affect the parts. WIPE THE MOTOR BASE (7) WITH A DAMP CLOTH. DO NOT IMMERSE IT IN WATER OR ANY OTHER LIQUID. REASSEMBLING 1. Replace the juicing chamber (5) onto the motor base (7) by sliding the protruding lugs at the back of the juicing chamber into the slots at the back of the motor base as shown in Figure 4. 2. Place cones (3) onto drive shafts (6). 3. Place the lid (1) in its original location. 4. Slide the drip tray (10) into position along guide rails, clipping rear tab into position. The juice container (8) will then slide into position for storage. ADVICE ON DISPOSAL: Our goods come in optimized packaging. This basically consists in using non- contaminating materials which should be handed over to the local waste disposal service as secondary raw materials. Before throwing a used appliance away, you should first make it noticeably inoperable and be certain to dispose of it in accordance with current national laws. Your Retailer, Town Hall or Local Council can give you detailed information about this. This appliance is labeled in accordance with European Directive 2002/96/EC – concerning used electrical and electronic appliances (waste electrical and electronic equipment – WEEE). This product must not be disposed together with the domestic waste. This product has to be disposed at an authorised place for recycling of electrical and electronic appliances. The guideline determines the framework for the return and recycling of used appliances as applicable throughout the EU. Please ask your dealer about current means of disposal. FRANCAIS 1. Couvercle a cuillere demontable pour son entretient 2. Baguettes pour fixer le couvercle 3. Cones presse-citron avec paniers filtre 4. Emplacement des fruits pour la coupe 5. Chambre a exprimer 6. Axe tournants 7. Base du moteur 8. Reservoir a jus 9. Passoire pour la pulpe et les graines 10. Plateau demontable pour l’egouttement du jus 11. Interrupteur “O” “I” 12. Emplacement pour le cable (sous l’appareil) 13. Levier avant de demontage BRANCHEMENT AU RESEAU Brancher uniquement sur des tensions indiquees sur la plaque de caracteristiques. Ces appareils repondent a la Directive Communautaire sur la suppression d’Interferences de radio. INSTRUCTIONS DE SECURITE : • Lire attentivement le mode d’emploi. • Raccordez a une prise de courant. • Ne pas laisser le presse-citron sans surveillance pendant qu’il est en marche. • Faire tres attention lorsqu’il y a des enfants pres de l’appareil. • Toujours utiliser le presse citron sur une superficie seche et plane. • Avant de le mettre en marche, le presse citron devra avoir les deux cones (3) charges de fruits. L’appareil ne fonctionnera pas si on n’appuie que sur l’un des cones. • Ne pas introduire la base du moteur (7) dans de l’eau ni tout autre liquide. • Debrancher l’appareil du reseau si on ne l’utilise pas ou ava...